Catalogs >
PENN Engineering >
Self-Clinching Cable Tie Mounts

Self-Clinching Cable Tie Mounts
6Pages

Catalog excerpts

SELF-CLINCHING TY-D® CABLE TIE-MOUNTS AND HOOKS BULLETIN TD 212

SELF-CLINCHING TY-D® CABLE TIE-MOUNTS AND HOOKS PEM® TY-D® self-clinching tie-mounts and hooks provide secure attachment points for mounting wires to electronic chassis or enclosures. All TY-D hardware installs quickly and permanently without screws and eliminates the use of adhesives that typically fail over time and temperature cycling. Type TD™ mounts allow users to easily slide ties through the hardware’s “eye” for fast cable mounting. Type TDO™ hooks* enable users to attach, remove, and return tie-bundled wires to their mounting points when components need to be accessed for service or...

Open the catalog to page 2

SELF-CLINCHING TY-D® CABLE TIE-MOUNTS AND HOOKS CABLE TIE-MOUNTS (1) Reference to typical load rating (in pounds) for appropriate size nylon cable tie. PART NUMBER DESIGNATION Finish Code: Zinc on steel fasteners.

Open the catalog to page 3

SELF-CLINCHING TY-D® CABLE TIE-MOUNTS AND HOOKS TYPE TDO™ CABLE TIE HOOKS Hole In Sheet K .005”/0.13mm R Max. (TYP.) M A H J ØC D G F B I L E All dimensions are in inches. Min. Hole Min. Hole Edge To Edge To Sheet Edge Sheet Edge K M Profile (1) Length Code Length L ±.003 Sheet Thickness Hole Size In Sheet +.002 -.001 A ±.003 B ±.006 ØC ±.006 D ±.006 E ±.006 F ±.005 Height G Nom. H ±.010 I ±.010 J Nom. TDO 40 8 .246 .040 - .155 .250 x .375 .371 .213 .245 .130 .433 .285 .471 .12 .13 .083 .040 .147 TDO 50 8 .246 .040 - .155 .250 x .438 .434 .228 .270 .130 .496 .300 .517 .12 .13 .102 .040 .196...

Open the catalog to page 4

SELF-CLINCHING TY-D® CABLE TIE-MOUNTS AND HOOKS MATERIAL AND FINISH SPECIFICATIONS MATERIAL: Sintered Steel FINISH: Zl- Zinc plated, 5|jm, colorless <1> FOR USE IN SHEET HARDNESS: HRB 60 / HB 107 or less <2> (1) See REM Technical Support section of our web site for related plating standards and specifications. (2) HRB - Hardness Rockwell "B" Scale. HB - Hardness Brinell. Pull Thru- Pull Thru- (1) The values reported are averages when all installation specifications and procedures are followed. Variations in mounting hole size will affect results. Performance testing of this product in your...

Open the catalog to page 5

SELF-CLINCHING TY-D® CABLE TIE-MOUNTS AND HOOKS 1. Punch a properly sized rectangular mounting hole in the sheet. Do not perform any secondary operations such as 2. Place the fastener through the mounting hole (preferably the punch side) and into the anvil. With the punch and anvil surfaces parallel, apply a squeezing force until the bottom of the fastener becomes flush with the sheet. ANVIL DIMENSIONS NOTE: The punch must be large enough to cover the entire base of the fastener to ensure proper installation. PEMSERTER® PRESSES For best results we recommend using a PEMSERTER® press for...

Open the catalog to page 6