Catalogs >
PENN Engineering >
PEM® Six-Lobe Heavy Duty Clinch Studs

PEM® Six-Lobe Heavy Duty Clinch Studs
2Pages

Catalog excerpts

PEM® Six-Lobe Heavy Duty Clinch Studs - 1

PEM® Six-Lobe Heavy Duty Clinch Studs PEM® six-lobe heavy duty self-clinching studs are typically used when high torque out and pushout and, if necessary, high tensile/shear strength are required. These studs are easy to install, have a low installed cost, and have consistent performance characteristics. Available Features and Benefits H T Look for the PEM “dimple” trademark Six-lobe design • Head strength is adequate to develop full thread strength. • Can be used in material as thin as .036” / .91mm. • Easy to install. No welding. • Can be installed with automated equipment. • Installs into panels up to HRB 85 / HB 165. • Dog point and/or MAThread/MATpoint features available.(1) • Thread strength: grade 5 through 8 and property class 9.8 to 10.9 • RoHS compliant materials and finishes. Thread Size x Pitch (2) (1) PennEngineering is a licensee for MAThread®/MATpoint® technology, a registered trademark of MAThread Inc. (2) Part number will be assigned during quote process. www.pemnet.com

Open the catalog to page 1

PEM® Six-Lobe Heavy Duty Clinch Studs - 2

PEM® Six-Lobe Heavy Duty Clinch Studs Specifications Threads - External, ANSI B1.1 2A ANSI/ASME B1.13M 6g(1) Fastener Material - Heat-treated carbon steel (2) Standard Finish - Zinc plated 5µm colorless (3) For use in sheet hardness HRB 85 / HB 165 or less (1) For plated studs, Class 2A/6g, the maximum major and pitch diameter, after plating, may equal basic sizes and be gauged to Class 3A/4h. Per ANSI B1.1, Section 8, Table 3A and ANSI B1.13M, Section 8, paragraph 8.2. (2) Other materials available upon request. (3) Other finishes available upon request. Installation PEM® six-lobe heavy...

Open the catalog to page 2