The Leading Experts In Weighing & Dosing The LCS-3 is a simulator used as a substitute for strain-gage transducers to generate the precise mV/V signals required in the development, checkout and pre-calibration of signal conditioners, digital and analog readouts and data loggers. 3 mV/V, load simulation of 1 to 4 loadcells and sense test. Resistance equal to 350 ohm loadcells. Vernier knob for variable output ca. -2 mV/V to Includes 4 ft removable interconnect cable. with connector. • A completely passive unit. 9 Number of loadcells switch. • Low drift / High accuracy. cable with plug.

Loadcell Simulator: Lights when simulator is connected properly. Sets output polarity (plus or minus) for mV signal. Connects two resistors of 15 up to 75 Ohms in series with Plus and Minus excitation voltage, (total 30 - 150 Ohm) This function tests the integrity of the sense capability of the excitation voltage supplied by the indicator. This can be useful when safety barriers are being used. OUTPUT SIGNAL SWITCH Sets the output signal ratio from 0 to 3 mV/V depending of the excitation voltage. The zero position can be used to test the zero drift of the indicator. NUMBER OF LOADCELLS SWITCH...