The Leading Experts In Weighing & Dosing • Aluminum construction • Available with metric and UNC threads a EEx ia IIC T4 hazardous area approval • Bench scales • Counting scales • Grocery scales Model 1030 is a single-point load cell designed for direct mounting of low cost, low capacity weighing platforms. Its use in relatively large platforms, combined with high accuracy and low cost, makes this load cell ideally suited for a wide range of weighing applications, including bench scales, laboratory, money counting and process weighing. A special humidity resistant protective coating is available as an option which assures long-term reliability. Model 1030's built in overload stop can provide mechanical protection against overloading. The two additional sense wires feed back the voltage reaching the load cell. Complete compensation of changes in lead resistance due to temperature change and/or cable extension, is achieved by feeding this voltage into the appropriate electronics. OUTLINE DIMENSIONS in millimeters OVERLOAD STOP-- SPECIFIC APPLICATION BOTH MOUNTING FACES

Technical Data l1) 1030 is a non-balanced bridge load cell (3) IP67 available upon request All specifications subject to change without notice. WIRING SCHEMATIC DIAGRAM (Unbalanced bridge configuration) y^—^i +VE INPUT (Green) PENKO Engineering B.V. | Schutterweg 35, 6718 XC Ede | The Netherlands | Tel 0031 (0)318 525630 | Fax 0031 (0)318 529715 All product information and specifications are subject to change without prior notice. Copyright © 2011 PENKO. All Rights Reserved.