The Leading Experts In Weighing & Dosing • Aluminum construction • NTEP approved • Available with metric and UNC threads -> EEx ia IIC T4 hazardous area approval • Bench scales • Counting scales • Grocery scales Model 1010 is a single-point load cell designed for direct mounting of low cost, low capacity weighing platforms. Its use in large platforms, combined with its high accuracy and low cost, makes this load cell ideally suited for a large range of weighing applications, including bench scales A special humidity resistant protective coating is available which ensures long-term reliability. For hazardous environments this load cell has EEx ia IIC T4 level approved option. Model 1010's built-in overload stop can provide mechanical protection against overloading. The two additional sense wires feed back the voltage reaching the load cell. Complete compensation of changes in lead resistance due to temperature change and/or cable extension is achieved by feeding this voltage into the appropriate electronics. OUTLINE DIMENSIONS in millimeters

Technical Data * 1010 is non-balanced load cell (non-balanced bridge), 1015 is balanced ** IP67 available upon request All specifications subject to change without notice. WIRING SCHEMATIC DIAGRAM (1010) (Unbalanced bridge configuration) WIRING SCHEMATIC DIAGRAM (1015) (Balanced temperature compensation) PENKO Engineering B.V. | Schutterweg 35, 6718 XC Ede | The Netherlands | Tel 0031 (0)318 525630 | Fax 0031 (0)318 529715 All product information and specifications are subject to change without prior notice. Copyright © 2011 PENKO. All Rights Reserved.