OPCARD 2.2 is a complete ultrasonic testing device, suitable for all ultrasonic measurements and due to many additional digital inputs/outputs and internal processor it can be used as a controller for more complicated devices. The card can work together with devices like multiplexers or scanners. Opcard can work in sequence mode. It has possibility to store up to 1024 sets of settings. So parameters can be switched very fast for every next data acquisition. The system allows to buffer many acquisitions in internal memory and forward whole packet of data to control application. In this way, the high throughput of data reading from the device is obtained. The card has an implemented one channel pulser & receiver and can be used with one or with two transducers (one is sending, and the second one receiving). Technical Data - Low noise preamplifier (0.74 nV/V(Hz)) - High gain up to +89 dB - Switchable analog filters - Support fast TGC (time gain compensation) - 2 analog signal inputs PE and TT - Input attenuator (-20dB) - Input Impedance 50 Ohm, 10pF - 10bit A/D Converter - 100MHz sampling frequency, 8bit sample - Up to 512k x 16bit samples memory - Delay settings up to 65535 sample periods - various triggering mode - Data transfer speed - up to 132MB/s - Expansion Connector for extra functions daughter-board - interfaces (RS232, RS485, SPI, I2C) - Standard PCI short card (174.63mm x 106.68mm) - BNC or Lemo analog connectors - DB15 connector for I/O and power lines - weight: 175g Analog parameters: Input Amplifier Gain: Input PostAmplifier: Input Attenuator: Input Range: Full Bandwidth: Switchable Filters(-3dB): Przedsi^biorstwo Badawczo-Produkcyjne OPTEL Sp. z o.o. ul. Morelowskiego 30 PL-52-429 Wroclaw phone: +48 71 329 68 53 fax.: +48 71 329 68 52 e-mail: [email protected] http://www.optel.pl

Pulser: Pulse Voltage Charging Time Fall Time Pulse Duration Output impedance Data processing: Resolution Sampling Frequency(MHz) off(0V) to 360V (positive pulse, Short circuit step pulser) regulated from 0 to 3.1us in 0.1us steps <= 20 ns Short circuit, bandwidth up to about 50MHz < 1 Ohm Data Buffer Delay Time Hardware data processing: Hardware averaging Hardware digital filtering15 DAC (TGC) with arbitrary waveform generator: Frequency: 100MHz Max. gain changing: 48dB pro step Trigger: On-board trigger timer; Application trigger rate Software controlled; External trigger 2x inputs, TTL Signal....