VI786-A06 / VI700-A06 / VI700-B06
3Pages

This suspension system consists of rectangular cushions made of woven compressed stainless steel wire. The VI786 have a Ø 9 bored screw hole, so that they can be mounted in collars with the diameters required by the user. This suspension system is particularly suitable for mounting exhaust pipes from generator sets on board ship or permanently mounted in buildings. They are unaffected by aggressive chemicals, oil, grease and corrosion and withstand extreme temperatures from - 70°C to + 300°C. The natural frequency of between 15 and 20 Hz enables the pipes to be mounted independently of the support and thus reduces noise levels and allows the pipes to expand freely. (1) Natural frequencies with max/min loads, see : OPERATING CHARACTERISTICS. PAULSTRA - 61 rue Marius Aufan - 92309 Levallois-Perret Cedex - France - T. +33 1 40 89 53 31 - F. +33 1 47 25 28 96 www.paulstra-industry.com

Assembly : Countersunk screws can be used to mount the cushions inside the collar. The number of cushions used should be a multiple of 4, depending on the diameter of the pipework: see table below. However, for small diameter pipes, 2 collars can be used edge to edge, each having 2 pads at opposite diagonals. Max. dynamic force in compression : 800 daN. Static load range from 30 to 200 daN. Collars and screws not supplied.

I LO CD CM x-II II CD CD O O < CD Assembly : Our wide range of mounts can meet many requirements. These mounts should be used as shown in the following diagram (two half collars, in which the cushions are placed side by side, are connected to the structure). Note : the cushions may be mounted in two orientations : the height H is shown on the table. Refer to the drawing to ensure that the height H is correct when mounted. Choice : The cushions are 16 mm or 26 mm thick. We advise using VI700-B06 pads (16 mm thick) for 0 D pipes < 270 and VI700-A06 (25 mm thick) for 0 D pipes > 270. For...