Catalogs >
Paul Vahle GmbH & Co. KG >
Charging Contacts

Charging Contacts
8Pages

Catalog excerpts

MACHT STROM MOBIL Battery Charging Systems

The operation of Automatic Guided Vehicles (AGVs) requires high utilization of these vehicles in order to achieve an optimum of profitability. Often, recharge of the batteries which are required for the drive of the AGVs, presents a problem. A battery charger supplies current to the base plate. Once the AGV is in charging position and the collector has made contact with the base plate, the AGV computer turns on the current. The base plate has chamfered entry/exit ramps to facilitate smooth drive-on/drive-off of the spring loaded collector. Bristle brushes installed on the collector remove...

Open the catalog to page 3

AGV-Collector 2-phase, charging current 200 A Insulated collector for vehicle installation, with two contact brushes and a bristle cleaning brush. AGV-Base Plate 2-phase, charging current 200 A (1) Height at contact position

Open the catalog to page 4

AGV-Base Plate 2-phase, charging current 200 A Insulated Floor contact plate with two copper contact plates for charging and two pilot copper contact plates. (1) Height at contact position

Open the catalog to page 5

AGV-Base Plate single-phase, charging current 200 A Insulated Floor contact plate, complete with single copper contact. AGV-Collector single-phase, charging current 200 A Insulated collector for vehicle installation, with one contact brush and one bristle cleaning brush (to be used in pairs). AGV-Base Plate single-phase, charging current 600 A Insulated Floor contact plate, complete with single copper contact. AGV-Collector single-phase, charging current 600 A Insulated collector for vehicle installation, with three contact brushes and one bristle cleaning brush (to be used in pairs). (1)...

Open the catalog to page 6

AGV-Collector 2-phase, charging current 200 A Insulated collector for vehicle installation, with two contact brushes and cover pusher. AGV-Base Plate 2-phase, charging current 200 A Insulated Floor contact plate with two copper contacts, spring loaded cover and 2 x 2 m connecting cables. General installation instructions Install AGV-collectors on vehicle with bristle cleaning brushes in direction of travel. Install AGV-Base Plate on top of the floor. The *marked height 68 (65, 45) of AGV-Collectors type BLS is the dimension at contact position. Allowable tolerance: + 2 mm. In order to...

Open the catalog to page 7

Scope of delivery and services 1 Open conductor systems Open conductor systems la 2 Insulated conductor systems UlO 2a 3 Compact conductor systems VKS lO 3a 4 Enclosed conductor systems KBSL-KSL 4a 5 Contactless power supply Contactless power supply (CPS®) 5a 6 Data transmission VAHLE Powercom® 6a Slotted Microwave Guide (SMG) 6b 7 Positioning systems VAHLEAPOS® 7a VAHLE APOS® Optic 7b 8 Festoon systems and cables Festoon systems for D-tracks 8a Festoon systems for flatform cables on I-tracks 8b Festoon systems for round cables on I-tracks 8c Festoon systems for O-tracks 8d 9 Reels...

Open the catalog to page 8