ALTERNAX MORTISING MACHINE
3Pages

{{requestButtons}}

Catalog excerpts

ALTERNAX MORTISING MACHINE - 1

ALTERNAX MORTISING MACHINE METHODE TO SET THE TOOLS 1/ The setting should be done, the operator placed at the rear of the machine. 8 7 6 5 4 2/ Turn A to bring the central tool to its maximum travel to the left side. 3/ Lock by pushing on M. 8 7 6 5 4 Zero point 5/ Turn A in the way of the arrow to bring the central tool to the centre until it reaches its zero point. 6/ 8 7 6 5 4 Release M and do not touch A anymore.

Open the catalog to page 1
ALTERNAX MORTISING MACHINE - 2

7/ Unlock the handful of the carriage of the right lateral chisel and bring the carriage to its maximum travel to the right. 8 7 6 5 4 8/ Unlock the handful of the carriage of the left lateral chisel and bring the carriage to the dimension you want to realize (ex. 40 mm). Re-lock the handful. 8 7 6 5 4 10/ Turn A in the opposite way of the arrow to position the central tool to the left side until it reaches the left lateral chisel. 8 7 6 5 4 11/ Bring back slowly the central tool to the centre by turning A in the way of the arrow (this takes off the mechanical looseness). Make it over pass...

Open the catalog to page 2
ALTERNAX MORTISING MACHINE - 3

Central axis Central axis 14/ Proceed to the setting of the left lateral chisel compare to the central tool by using a small ruler. Placer the ruler flat on the face of the central tool and move A until you found the position where the left lateral chisel is the most forward compared to the ruler. Then unlock slowly the nut (screw) of the bolt that holds the chisel and bring the lateral chisel against the ruler. Put the lateral chisel even or lightly back compared to the central tool (0 mm for tools N°0 and N°1 / set back of 0,2 mm for tools N°2 and N°3). 15/ Tie the screw of the bolt that...

Open the catalog to page 3

All PARVEAU MMI catalogs and technical brochures

  1. CC5

    2 Pages

  2. AL3

    2 Pages

  3. CC3

    2 Pages