Technology Labs Parkinson Technologies houses and operates two state-of-the-art technology labs at its corporate headquarters in Woonsocket, Rhode Island. Customers use these facilities to evaluate equipment, conduct product/process development trials, produce samples for test marketing, and provide training on a broad variety of materials, including plastic film and sheet, nonwovens, and others. The Marshall and Williams Plastics Extrusion and Orientation Pilot Lab Facility is the most versatile plastic film and sheet extrusion and orientation laboratory commercially available for customer use. It provides a unique opportunity to develop products, optimize processes, generate samples for pre-marketing evaluation, and even produce low volume quantities of commercial materials. Typical Products Typical Materials • Cast film and sheet, monolayer and multilayer • Uniaxial and biaxial oriented substrates • Barrier films • Shrink labels and sleeves • Capacitor dielectric films • Battery separator membranes • Breathable membranes • Optical films • Opaque cavitated films • Other specialty films • Polypropylene • Polystyrene • Polyethylene • PET/PETG • PLA • PHA • PEEK • PVDF • PTFE • Other fluoropolymers • PA (Nylons) • EVA • EVOH © Parkinson Technologies Inc. Dusenbery® is a registered trademark of Parkinson Technologies.

Marshall and Williams Plastics Extrusion and Orientation Pilot Lab • Up to seven layer co-extrusion and 350 lb/hr • Optional twin screw extruder for in-line compounding • Dies • 12” Cloeren™ monolayer • 12” EDI™ triple manifold multilayer with “naked edge” skin layers and optional tie layer feedblock for four-layer and fivelayer structures • 20” Cloeren with seven-layer variable geometry feedblock • 24” EDI monolayer • Casting machine - two or three roll design with air knife, electrostatic wire, or polishing nip pinning devices • MDO - single stage, two-stage, patented Compression Roll Drawing...