Model 3100 Single Knife Cutter Dusenbery’s Model 3100 is a hydraulically driven linear feed single knife cutter that can cut most rolled products with ease, including textiles, nonwovens, plastics, rubber, pressure sensitive tape, film and more. Complete sequence programming makes for smooth operation- no lost time, no mistakes and no missed steps. With the Model 3100 you’re in control of entry speed, cut speed, knife speed, material speed, and direction. The machine’s knife positioning system, controlled through the PLC, holds a standard tolerance of +/-.005 inches allowing jobs to be completed accurately the first time through. The counter/totalizer package accommodates up to ten different slit widths with a cycle shutdown when the quantities are reached. Up to 1000 password protected recipes can be programmed to make start up fast and easy. The Model 3100 is fully upgradable and can be customized to fit particular converting needs. Options available are variable roll lengths up to 120” (length requirements that exceed 120” will be advised upon) JudAir chuck, a Borzon grinding system, a spray mist lubrication system, hydraulic end support, saw knife with exhaust for removal cutting, and Tufram/ anodized coated aluminum sleeves for core ID sizes from 2” to 8” to fit the 1.5” mandrel. Specifications Max. untrimmed web widths Max. roll weight (3” core) Available knife diameters www.parkinsontechnologies.com © Parkinson Technologies Inc. Dusenbery® is a registered trademark of Parkinson Technologies.

Standard Capabilities • Two speed knife entry system • Electronic digital knife positioning preselection in increments of .001” and holding tolerances of +/- .005” • Piggyback grinding system on the carriage grinds in the rear position or while cutting for increased productivity • Grinding mode selector, continuous or programmable in the back position Laser alignment assembly • 4-jaw Universal chuck creates positive gripping of roll and core • Linear ball bearing design for strong and smooth operation Spray mist system • Manually positioned shaft end support • Pre-wired, fully labeled circuitry...