Catalogs >
Parker bioscience and water filtration division >
Fulflo Mega-Flow Plus Filter Cartridges

Fulflo Mega-Flow Plus Filter Cartridges
1 / 2Pages

Catalog excerpts

Fulflo Mega-Flow Plus Filter Cartridges - 1

Fulflo® Mega-Flow ™ Plus Filter Cartridges Absolute-rated, high-flow capacity pleated cartridge Parker's Fulflo® Mega-Flow™ Plus cartridges are Ideally suited for high flow applications where aPsolute particle removal Is required. Each Mega-Flow Plus cartridge can handle significantly reducing the numPer of cartridges required as well as the housing size. Each 6 inch (152 mm) diameter Mega-Flow+ cartridge has flow capacity equal to 8 standard 2 1/2 Inch OD X 40 Inch long cartridges. Positive O-rlng seals and a built In handle make cartridge Installation reliable, fast and easy. Mega-Flow Plus cartridges are available with pleated polypropylene media for use in a wide variety of fluids. Absolute ratings range Contact Information Benefits Parker-Hannifin Corporation domnick hunter Process Filtration - North America High flow capacity means fewer cartridges and less time to change High flow capacity allows smaller Built in handle makes change fast, O-ring seal assures filtration Choice of polypropylene media expands fluid compatibility High surface area pleated design provides low pressure drop and long service life Polypropylene cartridges comply with FDA regs. per CFR Title 21 Horizontal and vertical housings available for flow rates up to Reduces process interruptions • Potable Water ENGINEERING YOUR SUCCESS.

Open the catalog to page 1

Fulflo Mega-Flow Plus Filter Cartridges - 2

Fulflo® Mega-Flow™ Plus Filter Cartridges Absolute Filtration Ratings • Polypropylene microfiber (P Code) • Cellulose with phenolic binder (C Code) Support Layers • Glass Filled Polypropylene • Buna-N, EPR, Silicone, Fluoroelastomer Recommended Operating Conditions: Change Out Differential Pressure Maximum Flow Rate Maximum Temperature Maximum Differential Pressure Surface Area Ordering Information Flow Rate and Pressure Drop Formulas Flow Rate (gpm) = Clean AP x Viscosity X Flow Factor Clean AP = Flow Rate x Viscosity x Flow Factor 1. Clean AP is psi differential at start. 2. Viscosity Is...

Open the catalog to page 2