Catalogs >
Panasonic Electric Works Europe >
GM1 Motion Controller firmware V1.4.0.0 (2023.11)

GM1 Motion Controller firmware V1.4.0.0 (2023.11)
3Pages

Catalog excerpts

GM1 Motion Controller firmware V1.4.0.0 (2023.11) - 1

Motion Controller GM1 Firmware Version-up V.1.4.0.0 Information you need to know before using the software (Essential reading) About Motion Controller GM1 Firmware Version-up file Ver1.4.0.0 is file to version-up GM1 Firmware to Ver1.4.0.0. Please version-up following the procedure in "How to Install". Caution Be aware of the following points listed below. This product incorporates the following software: (1) The software developed independently by or for Panasonic Industry Co., Ltd. ("Panasonic Industry") (2) The software owned by third party and licensed to Panasonic Holdings Corporation. (3) Software licensed under GNU General Public License Version 2.0 (GPL V2.0) (4) Software licensed under GNU Lesser General Public License Version 2.0 (LGPL V2.0) or Version 2.1 (LGPL V2.1) (5) Open source software licensed on conditions other than those of GPL V2.0, LGPL V2.0, or LGPL V2.1 Please refer to the copyright notice of those individuals at following license terms. Panasonic Corporation does not warrant anything regarding the use of this software. Panasonic Corporation will not assume responsibility of any sort for direct, indirect, repercussive, resulting or special damage that results from using this software or from the operation of the software itself. Panasonic Corporation does not restrict the use, copying or distribution of this software. However, when copying or distributing, Panasonic Corporation prohibits the procurement of fees other than the cost of media and prohibits the applying of restrictions in use of the software. Panasonic Industry Europe GmbH

Open the catalog to page 1

GM1 Motion Controller firmware V1.4.0.0 (2023.11) - 2

How to Install The firmware update consists of two hex files. 1. Create a GM Programmer project. Starting up GM Programmer, preparing project file to connect Motion Controller GM1 before version-up. 2. Execute the Network Scan function and connect to the GM1. 3. Select Online>Unit Version Upgrade from the menu bar, The "Unit Version Upgrade" dialog box appears. 4. Save .hex files to path for version update file Administrator privileges is required to save files to the default path. Click the [Select Path] button and specify a folder where .hex files are saved if you do not have...

Open the catalog to page 2

GM1 Motion Controller firmware V1.4.0.0 (2023.11) - 3

GM1 Firmware Detailed Version-Up Information Version-Up Information (Ver.1.3.0.3 to Ver. 1.4.0.0) (November 8, 2023 update) The following points have been upgraded. Expanded the maximum number of real axes for RTEX from 16 to 32 axes. Added MQTT client. Added DNS client. Added SNTP client. Added the project management function block. ■Corrected the following errors. Fixed FTP server timestamp information to local time display. Improved starting Controller if expansion units are connected. Fixed Digital input / output unit, Analog input / output unit and Pulse output unit too. Version-Up...

Open the catalog to page 3