Catalogs >
Panasonic Electric Works Europe >
Addressable multipurpose I/O unit 3361

Addressable multipurpose I/O unit 3361
2Pages

Catalog excerpts

Addressable multipurpose I/O unit 3361 - 1

Panasonic Electric Works Fire & Security Technology Europe AB Jungmansgatan 12, SE-211 19 Malmö, Sweden Tel: +46 (0)40 697 70 00 • Fax: +46 (0)40 697 70 99 info-fste@eu.pewg.panasonic.com • www.panasonic-fire-security.com Fire alarm systems Addressable multipurpose I/O unit 3361 • Two programmable outputs • Two programmable inputs General The unit has 14 screw terminals for cable connections. It has an LED indicator, see below. It is intended to be surface mounted and a plastic protection cover (with 10 cable inlets) is attached. When required, the unit can be mounted in a waterproof box (3362). Two outputs The unit has two programmable outputs: Relay output (Re0): NC or NO contacts (set via Win512). Relay output (Re1): NC or NO contacts (set via Win512). Two inputs The unit has two programmable inputs: Monitored input (two alternatives) ….used as zone line input (Z): The supplied end-of-line capacitor 470 nF shall be mounted in the last unit on the line. Short circuit could activate fault or fire alarm (set via Win512). This input is intended for conventional detectors. ….used as general input (In0): An input for a NC or NO contact (set via Win512 / Win128). Isolated input (In1): An optocoupler input (external 24 V DC / 8 mA is required). Normally low or high (set via Win512) / Win128. Connections / Settings The COM loop is connected directly to the unit via four screw terminals. The COM loop address is set with an Address setting tool 3314. The unit has an address label where the address is to be written. 3314 is also used to set the mode: NORMAL mode: I/O unit 3361. 2330 mode: Not used for 3361. 2312 mode: Not used for 3361. LED indicator 3361 has an LED, indicating communication to the unit, 2 flashes (5s interval) each 80th second or indicating fire alarm condition on the monitored zone line input (Z), 2 flashes each 2½ seconds. Waterproof box 3362 When required, the 3361 unit can be mounted in a waterproof box 3362 (IP 66/67). Product applications Used in the system EBL512 (SW version > 2.0) and EBL128. The unit is intended for indoor use and in dry premises (if not the waterproof box is used). It can be DIN rail mounted with help of a DIN rail interface kit 3363.

Open the catalog to page 1

Addressable multipurpose I/O unit 3361 - 2

All technical features and data are subject to changes without notice, resulting from continuous development and improvement. Product Leaflet Date of issue Revision / Date of revision MEW00126 2001-10-19 8 / 2008-09-24 Type numbers 3361 Addressable multipurpose I/O unit (incl. plastic protection cover). 3362 Waterproof box (IP 66/67) (incl. four compression glands). 3363 DIN rail interface kit, for symmetric 35 mm DIN rail (plate, clamp & screws) Technical data Voltage (V DC) allowed normal 12-30 15-30 when the monitored input is used as a zone line input (Z) 24 Current consumption at nom....

Open the catalog to page 2