1. Catalogs
  2. Panametrics
  3. Moisture Target™ Series 6

Moisture Target™ Series 6
1 /4Pages

Moisture Target™ Series 6

Moisture Target™ Series 6
1 /4Pages

Catalog excerpts

Moisture Target™ Series 6-1

Moisture Target™ Series 6 Moisture analyzer Low cost, real-time moisture measurement The Moisture Target Series 6 is an economical, single channel, aluminum oxide hygrometer in the Moisture Series line of analyzers. It is intended for OEM applications requiring low-cost, accurate, real-time moisture measurement.

 Open the catalog to page 1
Moisture Target™ Series 6-2

Moisture Target™ Series 6 Datasheet I PANAMETRICS • Low-cost, single-channel hygrometer for OEM applications • M Series moisture probe or VeriDri moisture transmitter compatible • NEMA 4 weatherproof membrane front display/keypad • Built-in isolated current or voltage analog output • MicroSD card for logging data up to 32 GB • Panel-mount and board-level configurations • Fail-safe fault alarm relay • Two Form C measurement alarm relays • Upgrades from MTS5 with adapter face plate This single-channel analyzer measures moisture in compressed air and gases. Designed for permanent installations,...

 Open the catalog to page 2
Moisture Target™ Series 6-3

Moisture Target™ Series 6 Datasheet । PANAMETRICS Technical Specifications Electronics Intrinsic safety External safety barrier for moisture input (optional) Warm-up time Meets specified accuracy within three minutes European compliance Complies with EMC directive 2004/108/EC and 2006/95/EC low voltage directive (Installation category II, pollution degree II) • Panel (front panel meets Type 4 and IP66) • Board version, without enclosure Moisture signal from Panametrics thin-film aluminum oxide moisture sensor on an M Series probe or VeriDri transmitter Analog output Single internal isolated recorder...

 Open the catalog to page 3
Moisture Target™ Series 6-4

Technical Specifications Moisture measurement Sensor type Thin-film aluminum oxide Moisture probe com- Compatible with all Panametrics M Series patibility aluminum oxide moisture probes and VeriDri transmitters Dew/frost point tem- Overall range capability: 140°F to –166°F perature (60°C to –110°C) • Standard 68°F to –112°F (20°C to –80°C) with data to -166°F (–110°C) • Extended 140°F to –85°F (60°C to –80°C) with data to 166°F (–110°C) VeriDri ranges include: • –110°C to 20°C • –110°C to –50°C • –90°C to 10°C • –80°C to –30°C • –80°C to 20°C • –30°C to 20°C • –130°F to 70°F • –130°F to –40°F...

 Open the catalog to page 4

All Panametrics catalogs and technical brochures

  1. PanaFlow FLI

    7  Pages

  2. XMO2pro

    6  Pages

  3. XMTCpro

    5  Pages

  4. HygroPro XP

    5  Pages

  5. HygroProII

    5  Pages

  6. PM880

    4  Pages

  7. MIS 2 Probe

    3  Pages

  8. M Series

    3  Pages

  9. moisture.IQ

    4  Pages

  10. OptiSonde™

    11  Pages

  11. Optica™

    15  Pages

  12. oxy.IQ

    6  Pages

  13. dew.IQ

    3  Pages

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.