Conveyor Applications PACLINE Customer Support Detailed installation and maintenance manuals Design and simulation using Solidworks Empty Carton Handling Trash Handling Powder Coating and Finishing Over/Under Parts Buffers Parts Accumulation and Storage Assembly Lines Technical information on our website Complete control capabilities Worldwide installation Distributed by: 1-800-955-8860 • [email protected]

Design Guidelines PACLINE Enclosed Track Conveyor An enclosed track overhead conveyor consists of a powered chain running within a round track. Loads are suspended from the chain pendants that stick out of the slot of the track. This conveyor is considered for synchronous operation, where the loads carried all move at the same speed. The chain can be stopped and started as desired, but all loads will react similarly. required. It can also run inverted with the pendant facing up in certain applications. Typical Conveyor Layout and Components A simple line drawing can depict your system layout...

Design Guidelines PACLINE Enclosed Track Conveyor An enclosed track overhead conveyor consists of a powered chain running within a round track. Loads are suspended from the chain pendants that stick out of the slot of the track. This conveyor is considered for synchronous operation, where the loads carried all move at the same speed. The chain can be stopped and started as desired, but all loads will react similarly. required. It can also run inverted with the pendant facing up in certain applications. Typical Conveyor Layout and Components A simple line drawing can depict your system layout...

Track Hanger Clamp TH-200 (with W threaded rod for ceiling or floor supports) Shown with AC 120 angle clip The special design of our TH-200 Track Hanger allows for location on any length of track including the vertical incline sections. The swiveling V2" threaded rod always locates in an upright position. To ensure adequate supports, we recommend that the following guide be used. Center Distance of Supports All components are zinc plated for corrosion resistance. The SB-450 is designed to mount onto the TH-200 Track Hanger for rigid support cross bracing. This unique clip will swivel to any angle...

Advantages of the PACLINE overhead conveyor system Track Hanger Clamp TH-200 Track Joining Flange TF-204 (with ½” threaded rod for ceiling or floor supports) Shown with AC 120 angle clip The special design of our TH-200 Track Hanger allows for location on any length of track including the vertical incline sections. The swiveling ½” threaded rod always locates in an upright position. To ensure adequate supports, we recommend that the following guide be used. All standard 5’ and 10’ track sections, curves, drives and take-ups include the track flanges on each end for ease of assembly. Where standard...

PACLINE Customer Support maintenance manuals using Solidworks Technical information Complete control capabilities Worldwide installation Empty Carton Handling Powder Coating and Finishing Parts Accumulation and Storage Trash Handling Over/Under Parts Buffers Assembly Lines OVERHEAD CONVEYORS