ACX Series Single-Phase High-Density AC Power Sources - 4 Pages

Add to MyDirectIndustry favorites
ACX Series  Single-Phase High-Density AC Power Sources

Catalog excerpts

Single-Phase High-Density AC Power Sources 1000 VA 1500 VA 1800 VA 15-1200 Hz 150/300 VAC Standard Features: • Single Phase, Dual Range 150/300 VAC Output • 15 to 1200 Hz. Full Power Operation – 5000 Hz small signal bandwidth • Universal (115-240V, 1Ø, 50/60Hz.) PFC input with inrush current limiting • 10A Universal Front Panel Output Receptacle and 20A Rated Rear Panel Output Terminals • Precision Voltage Programming – 0.05% with Continuous Self-Calibration (CSC) engaged • True-RMS metering of volts, amps, and power • GPIB (IEEE-488.2) or RS-232 Interface The ACX-Series consist of three compact, single-phase programmable AC power sources spanning a power output range from 1000VA to 1800VA. The 1800VA capable 118ACX represents one of the highest power density AC power sources available. All ACX models offer low acoustic noise levels, ease of installation and a wide range of features. Using state-ofthe-art, high frequency, pulse-width-modulated (PWM) power conversion technology, ACX models offer a terrific value. Convenient to operate from the front panel keypad or remote interface, the ACX Series models are ideal for AC Power simulation, automated testing, frequency conversion, laboratory, and bench-top power applications. • Waveform Library – Arbitrary Waveform Generator All ACX models are equipped with a powerful micro-controller with the ability to operate as a fully integrated test system. They can supply a variety of power conditions and transients to the device under test while metering and analyzing all output performance parameters. • Transient Programming FREQUENCY/ VOLTAGE CONVERSION • 99 stored programs with associated transients for static and dynamic test applications The ACX models are excellent sources of stable AC Voltage over a frequency range of 15 to 1200 Hz. The output frequency is quartz-crystal stabilized. Output voltages up to 300 Vrms are supported. • UPC Studio Software Suite • Peak Inrush Capture Worldwide input voltages and power frequencies are accommodated by the wide range, power-factor-corrected (PFC), input power supply. Inrush current limiting permits operation in laboratories with soft or limited input service. Compliance to CE, CSA, and UL test standards adds confidence to the design and allows the product to be shipped anywhere in the world. • Country Specific AC Input Line Cord Available options: • GPIB (IEEE-488.2) Interface • Harmonic Analysis and Waveform Synthesis UPC Manager Software Suite Master the Power of the Wave! UPC Manager Software gives you the tools necessary to quickly and easily operate your AC Power Source. With our intuitive graphical interface, control all areas of AC Power Source testing with simple presets, user prompts, test sequences, test plans and custom reports. The ACX Series provides the same advanced features as found in higher power Pacific Power Source models. Providing both manual and programmable control, the ACX is fully compatible with Pacific's UPC Studio and UPC Test Manager software. The Leader in AC Power Technology An early pioneer in the development of solid-state power conversion equipment, Pacific Power Source continues to develop, manufacture, and market both linear and highperformance PWM AC Power Sources. Pacific's reputation as a market and technology leader is best demonstrated by its continuing investments in both research and development and world-wide customer support. With corporate owned offices in the United States, Germany, the United Kingdom and China, local personalized support is always nearby. FREQUENCY CONVERSION

 Open the catalog to page 1

ACX SERIES Output Ratings by Model MODEL Voltage Max2 (Vrms l-n/l-l) Current3 (Rated / Max. Arms) 150V Range 300V Range 11 / 16.5 NOTES: 1. Rated output power is based on a combination of nominal output voltage, rated current and load power factor. 2. Vmax is maximum RMS output voltage with full rated load applied. 3. Available current will vary with output voltage and power factor. See "Output Rating Charts" below. Values shown in table are Rated RMS Current and absolute maximum RMS Current. Output Specifications (applies to all ACX Models) VOLTAGE Range Resolution Accuracy 0 - 150 / 0 -...

 Open the catalog to page 2

ACX SERIES Total Control, Metering, and Analysis of AC Power - Simple, Intuitive Operation Output Slew Control Program Enter, Edit and Store Keys Program and Transient Execution Keys 4 x 40 Character LCD Display Help, Measurements and Function Key Unlike other manufacturers' products at this price point, the ACX Series are full featured programmable AC Power Sources. The Universal Programmable Controller (UPC) used in the ACX not only supports frequency and voltage programming, it also supports extensive transient programming, programmable voltage and frequency slew rates, arbitrary...

 Open the catalog to page 3

The ACX is designed for bench top or 19"equipment rack operation. Shown with provided rack mount handles. General and Environmental Specifications OPERATING Full Power TEMPERATURE Derated HUMIDITY Relative Mechanical Specifications MAX. ALTITUDE 3000 m / 10000 feet ENVIROMENT Pollution Degree 2 CONNECTORS Input Power Rear Panel LISTINGS CE Mark, NTRL CCL 18.2 kg / 40 lbs 21 kg / 47 lbs Screw Terminal Block (L, N, G) Safety cover w/ strain relief (Optional regional line cords available) Output Power Universal Socket 10A Max., Fused Country Specific Line Cord Options UPC TEST Test Executive...

 Open the catalog to page 4

All Pacific Power Source catalogs and technical brochures


    2 Pages

  2. Model 305AMX

    4 Pages

  3. Model 345AMX

    4 Pages

  4. Model 108AMX

    4 Pages

  5. Model 3120-ASX

    4 Pages

  6. Model 120ASX

    4 Pages