PINK NEXT GEN® FIBERGLAS” INSULATION Owens Coming® PINK Next Gen® Fiberglas™ insulation is a preformed, flexible blanket insulation. It is produced in R-values from 11 to 49, with thicknesses ranging from 3^ inches to 14 inches. It is available unfaced, or faced with either a Kraft vapor retarder. • Proven thermal control and sound dampening • Improved recovery and stiffness for fast install • Long-term performance. Will not settle or slump within wall cavities • Soft as cotton and shed-resistant with less dust • Compression packaging for easier handling • Manufactured in compliance with ASTM C665 • Classified non-combustible as tested in accordance with ASTM E136 (unfaced only) • Unfaced PINK Next Gen® Fiberglas™ insulation is acceptable for use in ICC building construction types I through V; Kraft PINK Next Gen® Fiberglas™ insulation is acceptable for use in ICC building construction types III, IV, and V • Certified to meet California Code of Regulations, Title 24, Chapter 12—13, Article 3, "Standards for Insulating Material" Physical Properties 1 The surface burning characteristics of insulation were derived from products tested in accordance with ASTM E84. This standard is used solely to measure and describe properties of products in response to heat and flame under controlled laboratory conditions, and should not be used to describe or approve the fire hazard of materials under actual fire conditions. However, the results of these tests may be used as elements of a fire risk assessment that takes into account all of the factors pertinent to an assessment of the fire hazard of a particular end use. Values are reported to the nearest five rating. Applications • Wood-framed wall, floor, and roof/ceiling cavity applications • Metal-framed wall and floor cavity applications • Interior surfaces of basement and unvented crawl space foundation walls Design Considerations • For optimum insulation performance, the building thermal barrier (insulation) should be in continual alignment with the building air barrier. In framed cavities, the product thickness should match the depth of the framing members. • Follow the local, applicable building code(s) to determine the need for and placement of a vapor retarder. • Do not install insulation on top, or within 3 inches, of a recessed light fixture unless the fixture is labeled as "insulation contact" (IC) rated. • Kraft facing will burn and cannot be left exposed. Install facings in substantial contact with a thermal barrier (min V211 gypsum dry wall). Protect from open flame or other heat source. Product Data Sheet | PINK Next Gen® Fiberglas™ Insulation

5 Manufacturing thicknesses may vary and yet will still deliver the branded/stamped R-value as per Owens Corning internal testing. Contact Owens Corning Sales for specific production run data as needed. NOTE: Owens Corning will require Master Pack product label to provide such data. Certifications and Sustainable Features • GREENGUARD Certified products are certified to GREENGUARD standards for low chemical emissions into indoor air during product usage. GREENGUARD validated to be formaldehyde-free. For more information, visit ul.com/gg • Environmental Product Declaration (EPD) has been verified...