Catalogs >
Otto Bihler Maschinenfabrik GmbH & Co. KG >
GSE K1 K2 K3

GSE K1 K2 K3
1 / 4Pages

Catalog excerpts

Compact NC Tapping Units for limited spaces – Patented, computer-controlled unit for extended field of applications – Installation in press units, assembly and transfer lines etc. – Flat design due to NC servo sleeve shaft motor – Separate control, independent units – Working stroke without pitch leader – For any metric or inch sizes within the indicated range – Thread forming and thread cutting – Quick-change device for tooling – Unit completely maintenance-free

Open the catalog to page 1

The control unit is situated in an air-conditioned control cabinet on casters with a height of 1600 mm. A maximum of 4 GSE-K units can be actuated from a single cabinet. Operation via a coloured 5,7‘‘ Touch Panel. Actuation possibility for optional lubrication of thread former. The unit is also equipped with a standard cooling unit which is sufficient for 2 GSE-K units and installed on one side of the control cabinet. A multiple spline shaft slides inside the sleeve shaft of the servomotor which executes the working stroke. During the advance movement the multiple spline shaft is...

Open the catalog to page 2

Machine / number of cycles (1/min) Performance diagram GSE K1 for ST 39 / brass operating angle 270° operating angle 240° operating angle 180° Thread size metric (M..) Performance diagram GSE K2 for ST 37 / brass Machine / number of cycles (1/min) operating angle 270° operating angle 240° operating angle 180° Thread size metric (M..) Performance diagram GSE K3 for ST 37 / brass Machine / number of cycles (1/min) operating angle 270° operating angle 240° operating angle 180° Thread size metric (M..)

Open the catalog to page 3

Otto Bihler Maschinenfabrik GmbH & Co. KG Lechbrucker Str. 15 | D-87642 Halblech Tel.: +49-(0) 8368/18-0 Fax: +49-(0) 8368/18-105 verkauf@bihler.de www.bihler.de

Open the catalog to page 4