Catalogs >
OSG >
AE-VMS

AE-VMS
8Pages

Add to favorites

Catalog excerpts

j^OOLS • ECOty

Open the catalog to page 1

1 Duarise coating 2 Positive rake angle

Open the catalog to page 2

AE-VMS: the A-brand end mill 1 Duarise coating The new duarise coating provides excellent lubricity, superior friction-resistance and high oxidation temperature. Multi-layer construction minimizes the thermal cracks that often occurred while using water-soluble oil. AE-VMS Multi-Layer Construction Adhesion Reinforcing Layer Smoothing surface coating treatment made an excellent quality of surface finishing. 2 Positive rake angle A stable performance is gathered by reducing cutting forces as a result of a sharp and positive rake angle. 3 New flute form The new flute form with its excellent...

Open the catalog to page 3

Application Contour Milling Applicable work materials Mild Steel Carbon Steel

Open the catalog to page 4

1. The above milling condition is a guideline for the overhang length is 3xD. 2. Use a rigid and precise machine and holder. 3. The rotational speed is calculated by the median of the recommended cutting speed. Adjustment may be necessary depending on the rigidity of the workpiece fixture and machine. 4. Please use a suitable fluid with high smoke retardant properties. 5. During dry (no fluid) milling, please use air blow to remove disposable chips from the milling area and to eliminate chip packing. 6. Please use water-soluble oil when machining stainless steel. 7. Reduce speed and feed as...

Open the catalog to page 5

Cutting Data Suppression of Burrs Great surface finish without vibration and minimal burrs. Tool Work Material Cutting Speed Feed Rate Water Soluble Vertical Machining Center Stable Performance Stable performance on stainless steel (mm) Cutting Speed Feed Rate Water Soluble Vertical Machining Center Work Material Cutting edge wear comparison AE-VMS 56m Milling Length

Open the catalog to page 6

Cutting Data Suppression of Burrs Suppression of cutting heat generation minimizes tool wear (mm) Work Material Cutting Speed Feed Rate Vertical Machining Center Flank Wear Milling Length Surface roughness comparison Surface roughness after milling 11,2m AE-VMS (Ra: 0.6377µm) Tool condition comparison Tool condition after milling 156,8m Cutting Chips Wear Comparison No Cutting Edge Recession Brown about 500°C 1mm Competitor A Purple about 600°C Excessive Cutting Edge Recession Minimal Cutting Edge Recession Blue about 70

Open the catalog to page 7

01/2017 - All rights reserved. © OSG Europe 2016. The contents of this catalogue are provided to you for viewing only. They are not intended for reproduction either in part or in whole in this or other medium. They cannot be copied, used to create derivation work or used for any reason, by means without the express, written permission of the copyright owner. If prices are stated, they are netto unit-prices and any eventual tax(es) have to be added. The company is not responsable for any printing error in technical, price and/or any other data. Tool specifications subject to change without...

Open the catalog to page 8