OSA 5320 PTP Slave Oscilloquartz SA / Rue des Brévards 16 / CH-2002 Neuchâtel Switzerland / Tel.+41(0)32 722 55 55 / Fax+41(0)32 722 55 56 [email protected] / www.oscilloquartz.com Stand-alone PTP - IEEE 1588-2008 Slave clock supplying highly stable Frequency, Phase and Time-of-Day synchronization signals The Precision Time Protocol (PTP) is a solution for the distribution of synchronization over IP-based packet networks such as IP, IP/MPLS, Ethernet, IP/xPON and IP/ xDSL networks. PTP is also known by the name of the corresponding standard IEEE 1588-2008. Oscilloquartz offers a comprehensive range of PTP products covering all synchronization needs in the telecommunication domain. The OSA 5320 PTP Slave is designed to operate with PTP grandmaster clocks from Oscilloquartz or from other vendors. The OSA 5320 consists of a PTP protocol engine which connects to one or several distant PTP Grandmaster clocks over an IP or Ethernet network. The PTP Slave is a high performance synchronization clock solution delivering frequency, phase and time-of-day over a set of output ports featuring a variety of output formats using Precision Time Protocol (PTP) over an Ethernet network. Highlights „Xƒn Delivers highly economic end-to-end frequency synchronization „Xƒn Up to 16 ppb frequency accuracy using Gigabit switches „Xƒn Precision timing circuits ensure stability in the event of synchronisation signal interruption. „Xƒn Slave system time accuracy better than 1 microsecond using Gigabit switches „Xƒn Configuration and alarm reporting capabilities using HTML and SyncView Plus „Xƒn Time-of-day (TOD) is provided using IRIG-B and NMEA 0183 Typical Applications „Xƒn Typical applications are the synchronization of 2G, 3G, LTE, cdma2000 and WiMAX base stations, RNC or Node B, of xPON optical line terminals, of DAB, DVB and DTV transmitters, etc. „Xƒn PTP allows the distribution of accurate frequency, phase and time-of-day to these applications even in cases where the transport network is asynchronous. Introduction Benefits „Xƒn Powerful network delay analysis delivers full time alignment over hostile networks (including Layer 2 and Layer 3 routing). „Xƒn Acceptable Master Table or Best Master Clock Algorithm selection „Xƒn No need to install GPS antennas „Xƒn 2.048 Mbit/s, 1.544 Mbit/s and 2.048 MHz synchronization clock signal for legacy equipments „Xƒn Time-of-day and Phase clock for Power & Utilities and Broadcast applications „Xƒn Multicast & Unicast operation ideal for use in Telecom environment

Ed.07 March11/ORIS Oscilloquartz SA / Rue des Brévards 16 / CH-2002 Neuchâtel Switzerland / Tel.+41(0)32 722 55 55 / Fax+41(0)32 722 55 56 [email protected] / www.oscilloquartz.com Oscilloquartz SA reserves the right to change all specifications contained herein at any time without prior notice. OSA 5320 PTP Slave Stand-alone PTP - IEEE 1588-2008 Slave clock supplying highly stable Frequency, Phase and Time-of-Day synchronization signals Typical Characteristics Three OSA 5320 PTP Slave Solutions Three versions of the OSA 5320 PTP are available: „Xƒn Telecommunication (synchronization of BTS/NodeB/RNC)...