OSA 5230 GPS Receiver A Compact, cost efficient, high quality GPS-based synchronization solution for OEM & integrators Introduction Oscilloquartz announces the addition of a compact 5230 Management Software GPS Receiver to it’s portfolio of cost-efficient synchroni- The OSA 5230 GPS Receiver can be managed by any zation solutions for OEM and system integrators. Windows based PC connected to the equipment via an The 5230 GPS is specifically designed for the synchronization of 2G, 2.5G and 3G mobile telecommuni- RS-232 connection and running the Configuration and Monitoring software (CM SW). cations networks, SDH/SONET, ATM, LAN/WAN transport, The CM SW application provides an intuitive, easy-to-use utilities as well as Synchronous Ethernet. access for configuring the unit and examine its current Digital broadcasting and mobile location services such as E911 can also take advantage of this compact and economical synchronization solution. The OSA 5230 GPS Receiver conforms to G.811-/Stratum 1 quality synchronization reference while providing 8 individually configurable outputs at a fraction of the cost of currently available solutions. The OSA 5230 GPS Receiver incorporates an integrated GPS receiver and a highly accurate oven-controlled oscillator, which filters the received signal and provides a holdover quality typical of an SSU/BITS during an eventual loss of GPS signal or antenna failure. status such as the visible GPS satellites, the unit’s operational state, the status of the outputs, of the internal oscillator and so on. The unit also provides an alarm relay contact allowing existing communication system to retrieve basic status information. The OSA 5230 can be managed by the SyncViewTM reporting and control functions with Universal Module Interface (UMI). *Option BVA Provides 1 direct low noise frequency output and high accuracy hold over (Df/f < 2x10-11day, MTIE < 1s/24h). The OSA 5230 GPS Receiver is the natural choice as a synchronization source for UMTS, WCDMA and CdmaOne, Cdma 2000, as well as GPRS, CDMA and TDMA base station and mobile switches. Highlights Reliable, low cost, compact GPS receiver outputs individually configurable by switches 8 Aux input Clock Extractor Optional auxiliary input: E1 or frequency G.703 compliant E1 and 2.048 MHz outputs Input Selection GPS input GPS Receiver 8 Outputs: 2.048 MHz 2.048 Mbit 1 PPS 10 MHz Tracking & Holdover Oscillator * UTC locked 1 PPS and 10 MHz outputs BNC connectors for all inputs and outputs TOD compliant to NMEA0183 *10 MHz Low Noise UTC Time Information Microprocessor control Simultaneous tracking of up to 8 satellites Integrated high stability holdover functionality : - ITU-T G.811/Stratum 1 compliant when locked to GPS - ITU-T G.812 (I, V, VI) compliant holdover - ITU-T G.812 (I, V, VI) filtering of auxiliary input Status LED Alarm Contacts RS-232 Port OSA 5230 GPS Block Diagram *For BVA option only Oscilloquartz SA / Rue des Brévards 16 / CH-2002 Neuchâtel Switzerland / Tel.+41(0)32 722 55 55 / Fax+41(0)32 722 55 56 [email protected] / www.oscilloquartz.com Plus synchronization network management system for alarm

OSA 5230 GPS Receiver A Compact, cost efficient, high quality GPS-based synchronization solution for OEM & integrators Typical Applications Cellular networks like UMTS, GPRS and CDMA Satellite ground stations equipment Wireless and wireline telecom synchronization Time and frequency reference for power utilities and public services State and federal communication systems simulcast Time and frequency reference for test equipment and instruments Specialised ATM and LAN/WAN synchronization requirements Any systems requesting highly accurate Time & Frequency references DAB and DVB broadcasting systems...