*mydirectindustry

5020

Product catalog summary

Overview
The OSA 5020 Low Noise Distribution unit is a compact, cost-efficient solution designed for OEMs and integrators requiring high-quality frequency distribution. It is particularly suitable for applications where low phase noise is critical, such as satellite tracking stations and time and frequency laboratories.

Key Features

Reliable and low-cost with a compact design.
Supports input frequencies from 500 kHz to 50 MHz.
Provides 12 outputs with low additive phase noise.
Equipped with BNC connectors for all inputs and outputs.
Operates on an AC power supply ranging from 100-240 Vac.
Units can be cascaded to extend output capacity.

Technical Specifications

Power Supply: 100 to 240 VAC, 47 – 63 Hz, 10 W consumption.
Environmental: Operating temperature from 0 to 55°C, storage temperature from -10° to +60°C, humidity 0 to 95% non-condensing, MTBF >900,000 hours.
Configuration and Monitoring: No configuration required, alarm contact on Sub-D 9p connector.
Compliance: EMC and ESD certified to EN55022: 2005 and EN55024: 2005, safety conformance to EN60950: 2001.
Input Specifications: BNC female connector, frequency range 500 kHz to 50 MHz, 50 ohms impedance, nominal level 1 Vrms.
Mechanical: 19" rack mount, dimensions 43 x 484 x 310 mm, weight ~3kg.
Output Specifications: BNC female connector, frequency range 500 to 50 MHz, nominal level 1 Vrms, harmonic distortion < -40dB, non-harmonic distortion < -80dB, impedance 50 ohms, isolation > 90 dB.
Phase Noise: Additive SSB Phase noise at various bandwidths: 1Hz -120 dBc, 10Hz -135 dBc, 100Hz -145 dBc, 1kHz -155 dBc, 10 kHz -160 dBc.

Applications

Satellite ground stations equipment.
Time and frequency distribution units.
Systems requiring low phase noise distribution.

Note
Oscilloquartz SA reserves the right to change specifications without prior notice.

Catalog excerpts

A compact, cost efficient, high quality synchronization distribution solutior Typical applications A compact, cost efficient, high quality frequency distribution solution for OEM and integrators. The OSA 5020 is specifically designed for applica- tions where the phase noise characteristic is extremely important such as satellites tracking stations or time and frequency laboratories. The OSA 5020 Low Noise Distribution unit is very easy to install. The unit does not require any type of configuration as the output signals are direct image of input signal. The rack-mount unit is easily installed and smoothly integrates with existing > Satellite ground stations equipment > Time and frequency distribution unit > Any system requesting a low phase noise distribution unit equipment Signa > Reliable, low cost, compact > 12 outputs low additive phase noise > BNC connectors for all inputs and outputs extend total output capacity Oscilloquartz SA / Rue des Brevards 16 / CH-2002 Neuchatel [email protected] / www.oscilloquartz.com SWATCH GROUP ELECTRONIC SYSTEMS

Open the catalog to page 1

A compact, cost efficient, high quality synchronization distribution solutior Typical Characteristics Power supply: Input specifications: Output specifications: Alarm contact on Sub-D (normally open or closed) or not loaded: daisy chain Loss of signal-Level detection Environmental characteristics: Output specifications (continued) : > Additive SSB Phase noise (1 Hz Bandwidth) Level detection Oscilloquartz SA reserves the right to change all specifications contained herein at any time without prior notice. Oscilloquartz SA / Rue des Brevards 16 / CH-2002 Neuchatel [email protected] / www.oscilloquartz.com...

Open the catalog to page 2

5020

5020

Catalog excerpts

All Oscilloquartz SA catalogs and technical brochures