1.3.7.1 Standard OEM Pyroelectric Energy Sensors 2µJ to 20mJ 1.3.7.1 Sensors Features ֺ ֺ Compact ֺ ֺ Low Profile ֺ ֺ Low Cost PE10-S PE10-S-Q The following specifications refer to standard OEM sensors, and are to be understood as generic, describing sensor families. Ophir will be happy to help you with a specific solution for your particular application. Model Features PE10-S High sensitivity and rep rate PE10-S-Q Very compact Aperture mm Absorber Type Spectral Range µm (a) Surface Reflectivity % approx. Calibration Accuracy +/-% (a) Sensitivity (approx) at 1064nm Max Pulse Width (b) Maximum Pulse Rate pps (b) Maximum Energy Minimum Energy Noise Equivalent Energy, approx Output Damage Threshold J/cm2 <100nm 1µs 300µs Maximum Average Power W Maximum Average Power Density W/cm2 Dimensions Part Number 12 Metallic 0.19-3 50 3 100V/J into 1MΩ 25us 400 20mJ 2µJ 100nJ BNC 8 Metallic 0.19-3 50 3 15V/J into 1MΩ and 5nF load 500us 100 20mJ 2µJ 100nJ Flying Leads 0.1 0.2 4 2 50 Ø50.8 x 14mm Consult Ophir representative 0.1 0.2 4 2 50 30 x 40 x 14mm Consult Ophir representative Notes: (a) Notes: (b) PE10-S At calibrated wavelength, standard 1064nm. Others on request. There is a trade off between repetition rate, sensitivity and maximum pulse width. If standard products are not suitable, these parameters can be tailored to customer requirements. PE10-S-Q 78 01.01.2012 For latest updates please visit our website: www.ophiropt.com/photonics