Catalogs >
OMS Motion, Inc. >
OMD35 Integrated Stepper Drive & Controller

OMD35 Integrated Stepper Drive & Controller
2Pages

Catalog excerpts

OMD35 Integrated Stepper Drive & Controller - 1

DATA SHEET OMD35 Integrated Drive/Controller The OMD35 is a microstep motor driver integrated with an advanced motion controller. Capable of microstepping up to 1/256 steps the OMD35 can support 7 Amp of motor phase current. Its small design is compatible to mount directly on to a NEMA 23 stepper motor, and includes a through-hole in the center so the shaft of a linear actuator motor can pass through when mounted on the motor. Without the heat-sync the OMD35 will support up to 4 Amps. The connectors are screw terminal plugs for easy and secure wiring. Integrated Stepper Motor Drive and Controller RS485 communications (ModBus optional) Velocity = 0 to 2M steps per second Step resolutions include: full, 1/2, 1/4, 1/8, 1/16, 1/64, 1/128, 1/256. Single supply voltage +18VDC to +80VDC Up to 7.0 Amp phase current for high torque motors Center pass-through hole for linear actuator stepper motors Up to 4 Amps without a heat-sink Motor current and microstepping set through the interface for convenience Matches the NEMA 23 dimension for direct motor mounting Use existing motors or select the optimum motor for the application for cost control and best performance Screw-terminal connector plugs for convenient and reliable wiring LED indicator for status Automatic current decay mode detection Control signal inputs support +5 to +20V 15201 NW Greenbrier Pkwy, B-1 Beaverton, O

Open the catalog to page 1