Material Data Sheet Fluoroloy® A01 Features/Benefits: •Color: White •FDA compliant •Low gas permeability •Good cryogenic properties •Limited wear and heat resistance •Working Temperature Range: -268° to +260°C [-450° to +500°F] The table below represents typical values Properties1 PHYSICAL Specific Gravity MECHANICAL Tensile Strength Tensile Modulus Compressive Modulus mm/mm/°C [in/in/°F] mm/mm/°C [in/in/°F] THERMAL Linear Coefficient of Thermal Expansion 26° to 200°C [78° to 392°F] Mold Direction Cross Direction 1. All testing is performed at room temperature unless otherwise specified. 2. Compression Strength was measured at 1% Strain. 3. Deformation Under Load was tested at 13.8 MPa [2,000 psi] for 24 hours NOTE: The data listed falls within the normal range of properties but should not be used to establish specification limits nor used solely as the basis of design. Saint-Gobain Performance Plastics assumes no obligation or liability for any advice furnished by the Company or for results obtained with respect to the products. Saint-Gobain Performance Plastics – Seals OmniFlex and RACO are trademarks. DynaLip®, Fluoroloy®, Elgiloy®, Meldin®, Marathon®, OmniSeal® and Rulon® are registered trademarks. ©2009 Saint-Gobain Performance Plastics Corporation ™ USA: Garden Grove, CA Toll Free: (800) 544-0080 Fax: (714) 688-2701 Email: [email protected] Website: www.seals.saint-gobain.com www.rulon-meldin.com