HL Pro / HB SERIES DESICCANT DRYERS

Innovative Design is Now Within Reach OMI heatless and heated blower desiccant Dryers are: - Engineered for easy access, maximum efficiency and long life - Delivered in a state-of-the-art low profile package, making installation and operation a snap! Our low profile design allows for upright shipping and transportation Traditional design Low Profile for Easy Maintenance One look tells you that OMI desiccant Angled manifolds make valves easy to access and maintain dryers are like no others. Our low profile design provides easy access to key maintenance points at operator level for faster servicing...

Innovative Controls and Design Lower Energy Costs Our new dryers offer the state-of-the-art Energy Management A heated blower dryer with EMS can save you over € 20,000 in just 3 years! System (EMS) that maximises energy efficiency while maintaining a constant dew point. By using a humidity sensor to continuously monitor the dew point, EMS minimises the compressed air used in regeneration, and optimises heater € 29,916 and blower operation. € 19,944 Heated blower models are equipped with solid state soft starters that limit inrush current to ensure a smooth start and longer blower motor life....

Selecting the Right Desiccant Dryer It’s all about choices. Whether it’s lower operating costs or a lower capital investment, OMI has a desiccant dryer that fits your needs. What Differentiates OMI Desiccant Dryers OMI desiccant dryers are designed to virtually eliminate costly production interruptions due to moisture. All of our dryers use twin desiccant towers and strategically positioned valves for drying compressed air. Heatless dryers are lower in capital investment, but require a small portion of the dried compressed air to be diverted from the air system for desiccant regeneration. Switching...

Heatless Desiccant Dryers Drying: (1) From the air compressor, the air enters the dryer through a pre-filter (option) that removes contaminates to protect Drying tower Regeneration tower the desiccant. (2) The air is directed through the drying tower. (3) The desiccant removes moisture from the air through adsorption. (4) Dry air passes through an after-filter (option) removing any contaminate particles before entering into the air system. (5) A small amount of the compressed air (15%) is redirected to the regenerating tower. Regeneration: (1) Dry air flows in the reverse direction through the...

[a] Microprocessor Controller Controls valve switching to correctly direct air flow and operation of blowers and heaters. Protects the dryer via continuously monitoring operating parameters. [b] Environmental Protection IP54 rating provides protection against dust and moisture contamination (IP65 option for wash down applications). [c] Motor Protection/Soft Starter (heated blower only) Reduces inrush current and stress on the mechanical system. [D Power Supply Dryers operate at 50 Hz (all models) or 60 Hz (optional). Pneumatic options also available on heatless models. (e| Centrifugal Blower...

STANDARD REFERENCE CONDITIONS AVAILABLE OPTIONS • Working pressure: 7 bar • Inlet air temperature: 35 °C (50° max) • Dew point: CLASS 2 (-40°C) • Work/Purge cycle: 240/240 min. STANDARD VOLTAGE: • 400V/3ph/50Hz • Non-standard voltages: all models available in 60Hz version. • ANSI connection flanges. • Marine painting. • Remote control software. • Tower insulation. • Pre-installed filters.

OFFICINE MECCANICHE INDUSTRIALI Via dell’Artigianato, 34 - 34070 Fogliano Redipuglia (GO) - ITALY Tel. ++39.0481.488516 - Fax. 0481.489871 www.omi-italy.it e-mail: [email protected]