Anemometer Display with programmable relay output WM44-SS Small Control Unit The control unit WM44-SS, is a tool of high accuracy with 2 programmable alarm thresholds. Particularly suitable for the use in combination with the sensor or ANEMO4403 SAG105WR, it is nevertheless compatible with a wide range of sensors for rotary motion. It has 2 thresholds programmable relays (ALARM 1 and ALARM 2). The device can be easily installed on instrument panels, cabinet doors and various types of industrial enclosures.     Automatic deactivation of the relay under the threshold level Signalling by flashing display of intervention AL2 Selecting the mode for the alarm (intermittent, continuous, considered) Possibility of inversion of the output relay contacts PANEL VIEW  2-digit display (height 20 mm)  2 LED indicators status alarms (AL1 and AL2)  Indicator of units (Km / h or Mph) Each output relay, can be normally energized or de-energized at tripping. In the latching mode, the alarm 2 relay energizes when the wind speed set point is exceeded and remains energized until the equipment is switched off ANEMOMETRIC SENSOR Compatible with most common wind sensors:  Sensor power supply: 20V or 10Vdc  Type : 3 or 2 wires (see the wiring diagram)  RECOMMENDED working with our Anemo 4403 sensor device USER PREDEFINED INSTALLING CONFIGURATION Apart from user programmed parameters, you can save another alternative configuration, and you can recover it as many times you want, going back to P01 program step. 1 Nuova CEVA Automation. Via G.B. Signini 43. Briga Novarese (NO) ITALY Tel. +39 0322 93574 Fax +39 0322 953787 [email protected]

PROGRAMMING To access the configuration buttons, lever up the frontal cover in the lower crack indicated by “open to program”. To enter the configuration mode, press Enter and Escape buttons simultaneously for more than 2 seconds. Function buttons in program mode: Button Increase program steps (P00,P01..), options or thresholds to program Decrease program steps, options or thresholds to program Enter into the program step where it is located, validate options and thresholds and escapes to step program. Return to program steps. In range, it selects the digit to modify Programmation parameters:...

Electrical Featu Power supplyl Outputs Relays Sensors: Wiring diagram Optional litems Protective screen IP65 with protective glass cover. Nuova CEVA Automation. Via G.B. Signini43. Briga Novarese (NO) ITALY Tel. +39 0322 93574 Fax +39 0322 953787 [email protected]

External enclosure stainless steel. As a container for optional external enclosure is available in stainless steel with transparent porthole that allows to see the internal display. Pre-assembled Equipment On request, are available pre-assembled equipments for crane consists of: Anemometer SAG105WR with output pulse or ANEMO4403 Schneider Electric alarm beacon Magnet for a rapid fix of the component Lenght of cable need to be requested 4 Nuova CEVA Automation. Via G.B. Signini 43. Briga Novarese (NO) ITALY Tel. +39 0322 93574 Fax +39 0322 953787 [email protected] www.nuovace