Catalogs >
NT Tool >
"R"- ZERO HOLDER

"R"- ZERO HOLDER
9Pages

Catalog excerpts

PAT. Having run out problems at the tool tip? NT’s patented R-Zero collet chucks offer the solution to your T.I.R problems! With “R-Zero” function HDZ High precision Slim design Runout accuracy of the cutting edge can be adjusted as closely as to Zero with “R” Zero holder. Adjustment wrench 4 Screws FDC-AA grade collet is recommended. Rotor ring Conventional Collet Holder “R ” ZERO Holder Even when runout of cutting tool at chucking side is 1μm , runout at the edge is much larger when using conventional collet chuck. “R”-Zero Setter SPZ-2 Easy to measure runout accuracy ●Rotary holder support Any tool interface can be prepared. (BT, HSK, UTS, SK etc.) ●Holder pull-in device Enables tool change by pulling in (wih 4-8kN) and fixing the tool holder. “R” Zero holder is a collet chuck with a runout adjustment function to reduce the misalignment of the cutting edge. The accuracy can be adjusted to 0-2μm in short time. This high precision “R” Zero holder realizes invariant hole diameter, better surface roughness, and longer tool life. Mueasement range 0-460mm in length

Open the catalog to page 1

PAT. Example of Use Integration of processes φ2 φ0.4 φ5 φ2 +0.02 0 85 12.7 Aluminium 10.7 0.45 Work material:Stainless 86 holes/work Drill: φ2 high speed steel drill Conventional Holder Process1:Centering Conventional Holder Conventional Holder Requires about 20 minutes to achieve a runout of 3μm. Split of process Occurrence of hole deflection defect Process2: φ4.85 Drilling Process3: φ5.0 Reamering R Zero Holder Machining is divided into three processes ■Required time to adjust a runout to 2-3 μm 20 minutes R Zero Holder R Zero Holder 2 minutes ■By adjusting runout accuracy 2 processes...

Open the catalog to page 2