Transducer for crack monitoring, Load Tests and flat jacks tests. The isplacement transducers commonly used for the automatic and continuous acquisition of measurements during structural monitoring or load tests.Completely made of stainless steel, they can be equipped with eyelets for wall fixing or with spring testator for load tests with suitable support bracket and telescopic stand. Available with different measurement ranges. Engineering Solutions Contact us for: purchase, rental, quote. Via Albertini, 36/F8 c/o Gross Ancona 60131 Ancona (AN)

The electronic crack meter consists of a potentiometric-type displacement sensor that detects changes in position between two points straddling a lesion or a joint. It is made entirely of aluminum, nylon and stainless steel and is equipped with self-aligning joints and a whole range of optional accessories for correct installation even in the most difficult cracking situations (cracks at corners, edges, etc.). The electric crack meter is a valid tool for manual or automatic control of the measurements of small displacements. The data can be read through the use of a portable control unit or through...

Engineering Solutions Contact us for: purchase, rental, quote. Via Albertini, 36/F8 c/o Gross Ancona 60131 Ancona (AN)

Displacement transducers • Fitting for attachment to the head of strain gauges • Signal cable • Support bracket (optional) Electronic crack meters • NOVA-FS 50 electronic crack meter (100 and 150 mm range available on request) • Aligned joints • Extension rods in stainless steel • Ground or rock anchors Engineering Solutions Contact us for: purchase, rental, quote. Via Albertini, 36/F8 c/o Gross Ancona 60131 Ancona (AN)