Catalogs >
NOV Inc. >
WVM Mixers

WVM Mixers
1 / 2Pages

Catalog excerpts

Kenics® WVM Static Mixers for the Water Industry The Kenics Water Vortex Mixer (WVM) builds on the HEV static mixer to offer more flexibility for differing flow conditions and improved additive injection. Three different WVM designs are available. These allow the project design parameters of length and pressure drop to achieve a certain CoV within a certain time to be optimized. Pressure Loss Length to Achieve Mixture Quality (CoV) of 0.05 (5%) The WVM mixers consist of a simple wall additive injection point, a pre-distribution tab immediately downstream of the injection point and banks of trapezoidal shaped mixing elements. The number of banks of mixing elements varies depending on the mixture quality required for the process. The dimensions, angle of attack and spacing of the trapezoidal mixing elements varies between the WVM models A, B and C. The predistribution tab and the injection point design are the same for all WVM models. The pre-distribution tab was visually modeled and optimized in Chemineer’s laboratory before being modeled again using CFM (Computation Fluid Mixing) CoV = Coefficient of Variation, or ó/x is the standard deviation of additive concentrations in any samples divided by the mean mixed concentration of the additive, a commonly used and quantifiable measure of mixture quality. software. Additives injected at the wall of the pipe are spread into a horseshoe shape by the pre-distribution tab. Use of the pre-distribution tab allows the simplest of injectors to be used – either a flanged nozzle or a threaded boss to which the chemical injection line can be connected. A proprietary injection fittings with corporation cock shut off device can also be fitted to the wall mounted boss if required. The pre-distribution tab was shown to improve quantifiable mixture quality (CoV) by at least 10% over a wide range of flow rates compared to the use of a multihole sparger injector. The improvement in mixing at low Reynolds number (velocity 0.1 m/sec) conditions was the greatest. Visual modeling of the dispersion of red dye into water using the WVM pre distribution tab.

Open the catalog to page 1

CFM model showing distribution of additive from wall injection point WVM Mixing Elements The banks of WVM mixing elements are arranged in line with each other but off centre with respect to the predistribution tab. The horseshoe shaped pre-distributed additive is then caught by the tips of the first bank of WVM elements and drawn into the axially oriented spinning vortices behind them. Each element creates two vortices and each bank therefore creates eight. The successive banks maintain and intensify vortices throughout the length of the mixer and for some length downstream. Chemineer, Inc....

Open the catalog to page 2