TamAcryl 2000 is a blend of acrylic polymers used in conjunction with an accelerator and catalyst system. Upon mixing of the components, a chemical reaction occurs and a waterproof gel is formed. It is available in two grades - standard and slow set. KEY BENEFITS > Ultra-low viscosity > Swells up to 5% upon contact with water > Very Flexible > 100% > Good chemical resistance > Reacts even in the presence of mineral and saline conditions > Potable water certified > Incorporates anti-corrosion agents TYPICAL APPLICATIONS > Leak sealing > Injection tubes > Void filling > Soil stabilisation > Tightening up normet CONSTRUCTION CHEMICALS TECHNICAL DATA SHEET TECHNICAL DATA Reaction Times The reaction time can be varied to suit prevailing conditions. To ascertain accelerator dosage required use 2 clean disposable containers e.g. plastic cups used in vending machines. Pour an equal amount of Part A and Part B into separate containers, each container should be able to hold the contents of the other, see below. Using the reaction table as a guide, add the accelerator to the Part A and mix. Pour one container into the other repeatedly until the material gels. Use this as a guide to judge accelerator dosage.

TamAcryl 2000 n rmet Chemical resistance (42 days immersion at 25°C) APPLICATION GUIDELINES TamAcryl 2000 is injected at a ratio of 1:1 Part A: Part B by volume. Ideally using a Twin Piston Pump such as TP2 / TP4 Pump or if extremely careful a single component pump. Cleaning involves using water to remove the resin before it sets. Note: Once the accelerator is added to the Part A it should be used within 24 hours. YIELD 1 kg = 0.92 litres STORAGE TamAcryl 2000 should be stored at room temperature (min 4°C and max 30°C), kept dry and out of direct sunlight. If these conditions are maintained...