1. Catalogs
  2. Normet
  3. Spraymec NorRunner 100 DVC
video corpo

Spraymec NorRunner 100 DVC
1 /9Pages

Spraymec NorRunner 100 DVC

Spraymec NorRunner 100 DVC
1 /9Pages

Catalog excerpts

Spraymec NorRunner 100 DVC-1

Technical data sheet 100022942 09.02.2012 Equipment includes options and extra equipment. Features The Spraymec NorRunner 100 DVC is designed to be used in tunnel profiles up to 14.5 m in height and 20 m in width and offers a maximum longitudinal spraying reach of 8 m in up to 12 m high tunnel from one set-up. The NorRunner features the new NSP 30 concrete pump with a maximum theoretical output of 30 m3/h and an on-board compressor with a capacity of 12 m3/min with 7 bar constant pressure to deliver enough air for spraying operations. The state-of-the-art NorSmart control system is used to control all spraying, accelerator dosing and boom functions. Two 1,000 L plastic containers with heaters and mixers are provided for the accelerator. A hydraulically operated generator supplies electric power for heaters and mixers during driving, allowing safe operation during the winter season. The spraying operation can be powered either by diesel drive or by electric power packs. With the selected chassis and the best transmission on the market, high output hydraulic pumps can be used to run the compressor and concrete pump as well as all other functions needed. Independent operation without a high voltage system is crucial for sites in remote places. Normet reserves the right to change this specification without further notice. Normet Oy Ahmolantie 6 FI-74510 IISALMI, FINLAND

 Open the catalog to page 1
Spraymec NorRunner 100 DVC-2

Technical data sheet 100022942 09.02.2012 Technical specification CARRIER HIGH VOLTAGE ELECTRICS Diesel engine OM 501 LA V6, 11,9 L BlueTec 5 (Euro 5) Telligent -diesel engine control Gearbox Mercedes PowerShift G330-12/11, 63-0,77, semi automatic Drum brakes Parking brakes in axles 1,3 and 4 Steel springs Four axle -type Full power PTO with flange PTO behind the engine with flexible clutch, max 600 Nm Mid long cabin (+250 mm) Power supply for the electrical functions 1000 V, 50 Hz. Cable type 3 x 35 mm² + 3 x 6 mm² Hydraulically driven cable reel Cable length 150 m Cable in / out reeling function...

 Open the catalog to page 2
Spraymec NorRunner 100 DVC-3

Technical data sheet 100022942 09.02.2012 Technical specification CONTROL SYSTEM Integrated, seamless NorSmart control and disgnostic system. NorSmart controls: • Spray boom • Concrete pump • Accelerator dosing system • Safety requirements • Fault diagnostics • Data logging Air pressure-driven system with hose reel: • Tank capacity 40 L • Hose length 30 m • Working pressure 7 bar ROCK WALL WASHING SYSTEM Hydraulically operated pressure washer for wall: • Max. water pressure 180 bar • Max. water flow 90 L / min for wall washing WATER REEL AND TANK FIRE SUPPRESSION SYSTEM Hydraulically driven water...

 Open the catalog to page 3
Spraymec NorRunner 100 DVC-4

Technical data sheet 100022942 09.02.2012 Optional equipment HIGH VOLTAGE ELECTRICS SPARE PARTS 400 V, 50 Hz. Cable 3 x 95 mm² + 3 x 16 mm², 100 m 690 V, 50 Hz. Cable 3 x 50 mm² + 3 x 10 mm², 150 m With 690 V and 1000 V electrical systems, it is possible to use cables longer than 150 m. In these cases, cable length and size must be checked case by case Spare parts package A: Available for 3000 m3 of pumped concrete*. Include periodical service, most common wearing parts and most critical safety parts Spare parts package B: Available for 6000 m3 of pumped concrete*. Include periodical service,...

 Open the catalog to page 4
Spraymec NorRunner 100 DVC-5

Technical data sheet 100022942 09.02.2012 SIDE VIEW Basic machine. Transportation and driving dimensions SIDE VIEW Basic machine. Concrete pump in low position TOP VIEW Basic machine. Transportation and driving dimensions DIMENSIONS Length Width Height Wheel base Ground clearance as shown Normet reserves the right to change this specification without further notice. Ahmolantie 6 FI-74510 IISALMI, FINLAND

 Open the catalog to page 5
Spraymec NorRunner 100 DVC-6

Technical data sheet SUPPORT LEGS EXTENDED FRONT AND REAR VIEWS Support legs extended TURNING RADIUS Normet reserves the right to change this specification without further notice._ FI-74510 IISALMI, FINLAND [email protected]

 Open the catalog to page 6
Spraymec NorRunner 100 DVC-7

n^VIIIDff Technical data sheet COVERAGE AREA OF SB508 BOOM Normet reserves the right to change this specification without further notice.

 Open the catalog to page 7
Spraymec NorRunner 100 DVC-8

n^VIIIDff Technical data sheet REACH AREA Maximum spraying area REACH AREA Optimized spraying area Normet reserves the right to change this specification without further notice.

 Open the catalog to page 8
Spraymec NorRunner 100 DVC-9

Technical data sheet 100022942 09.02.2012 REACH AREA Minimum spraying area REACH AREA Maximum spraying reach SPRAYING AREAS Spraying area from one stand with: • maximum tunnel size • minimum tunnel size • optimized tunnel size Normet reserves the right to change this specification without further notice. Normet Oy Ahmolantie 6 FI-74510 IISALMI, FINLAND

 Open the catalog to page 9

All Normet catalogs and technical brochures

  1. MF 100

    12  Pages

  2. TamAcryl 2000

    2  Pages

  3. Alpha 30

    10  Pages

  4. Himec 9915 B

    6  Pages

  5. Minimec

    4  Pages

  6. BS 7622

    3  Pages

  7. Tornado

    5  Pages

  8. Alpha 15 TDH

    5  Pages

  9. Alpha 20

    6  Pages

  10. Scamec 2000 S

    5  Pages

  11. Utimec 1090 D

    3  Pages

  12. Multimec 6600

    3  Pages

  13. Multimec 1000

    3  Pages

  14. Himec 9915 BA

    4  Pages

  15. Himec 1905 B

    3  Pages

  16. Himec 1125 B

    3  Pages

  17. Himec 9905 BT

    3  Pages

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.