T-SADDLE MULTI FITTINGS & JOINTS/ MULTI-MATERIAL T-SADDLE, MULTI-MAINS PRODUCT'S ADVANTAGES zz All in one : a single reference for multiple DNs of main pipes. zz For all types of mains : corrugated or smooth. zz Multimaterial : outlet sleeve with NORHAM flexible couplings technology. zz Watertight : up to 0,5 bar with an angular deflection of 10°. ALL MATERIALS AND MULTI-DN EU PATENT 3324093 FITTINGS & JOINTS

T-SADDLE MULTI FITTINGS & JOINTS/ MULTI-MATERIAL T-SADDLE, MULTI-MAINS AREA OF USE The T-SADDLE MULTI is intended for all gravity flow networks : • sewage ; It fits to all types of mains : • corrugated pipes ; • smooth pipes. Cast iron Thanks to its sealing (from the inside) and its clamping system, the T-SADDLE MULTI can guarantee a watertightness on main pipes of different DN and thicknesses. TECHNICAL DATA, CHARACTERISTICS AND DIMENSIONS Materials : •  pper and lower saddle : polyester u isophthalic resin reinforced with glass fibers ; •  lamp and locking system : 304 stainless c steel ; • ...

T-SADDLE MULTI FITTINGS & JOINTS/ MULTI-MATERIAL T-SADDLE, MULTI-MAINS ADVANTAGES OF THE SADDLE T-SADDLE MULTI does not require specific tools. Fast assembly ≈ less than 2 minutes. All in one. Thanks to its patented system, one reference for several main pipes (European patent No. 3324093). Non-through system in the main pipe. Reduced dimensions. Drilling tolerance of 0/+10mm compared to the nominal diameter drilling. (320-330 mm for the TF250MULTI). Watertightness system. Made by a foam seal on the inner wall of the main (principle of the "pressure cooker"). Easy to install. Holding and centering...

T-SADDLE MULTI FITTINGS & JOINTS/ MULTI-MATERIAL T-SADDLE, MULTI-MAINS INSTALLATION Tools needed* : •  core drill and drill bit Ø 320 mm ; •  lectric screwdriver (recommended e with socket of 8) ; •  wrench Ø 8 ; •  screwdriver ; •  measureing tape ; •  brush and lubricant ; •  tracing tools (felt...). Summary of the installation instructions supplied with the T-SADDLE MULTI. 1. rill and check the drilling Ø and the good D condition of the inner surface of the main. 2. Locate the "centering" axis of the drilling. 3. old the lower saddle in half and insert it F into the main. 4. Reassemble the...