Cross-Cut® Airless Spray Gun Nozzles Nozzles provide superior atomization and control when spraying high-solids, viscous and other hard-to-atomize materials. Finishers are continually challenged with maintaining excellent product quality and coating performance throughout each stage of their operations. In the past, spraying high-solids, viscous and other hard-to-atomize coatings and materials has been possible either by adding solvents, heating the material or increasing fluid pressure. The use of solvents adds cost and time to build the desired film thickness. Plus, increasingly stringent environmental regulations for reduced VOC emissions make this alternative more prohibitive. And increasing fluid pressure – in excess of 1000 psi – to improve atomization creates overspray and bounceback. This results in wasted coating material, increased equipment wear and shop environment problems for other personnel. Nozzle Design Nordson Cross-Cut nozzles are designed to provide improved atomization with a wide range of materials, including highly viscous and difficult-to-atomize coatings. Cross-Cut nozzles produce greater atomizing energy at a given fluid pressure, compared to conventional airless spray nozzles. Excellent atomization is achieved at reduced fluid pressure, resulting in a softer, low-velocity spray which helps minimize dripping, material waste and equipment wear for maximum coating efficiency and material utilization. Meets Varying Requirements Whether your coating operation is electrostatic or nonelectrostatic, manual or automatic, over 1,200 Nordson Cross-Cut nozzles in a wide range of nozzle types, spray pattern widths and flow rates are available, or can be customdesigned, to meet your specific application requirements. Nordson Cross-Cut nozzles produce greater atomizing energy at a given fluid pressure. This provides better control and less waste for maximum material efficiency and utilization.

Cross-Cut® Airless Spray Gun Nozzles Advantages of the Nordson Cross-Cut Nozzle Design Wider Fan Patterns Improved Film Deposition Nordson Cross-Cut nozzles produce significantly wider fan patterns than conventional airless nozzles. Patterns up to 28 inches wide can be achieved with Cross-Cut nozzles. On automatic systems this can reduce the number of guns or permit the use of less costly fixed gun systems in place of reciprocators and gun movers. Wider fan patterns combined with lower flow rates provide optimum film deposition even at low line speeds. Now you can take advantage of the benefits...

Cross-Cut® Airless Spray Gun Nozzles Fine Atomization at Lower Pressures With standard airless nozzles, internal turbulence and frictional losses reduce available energy for atomization. Nordson Cross-Cut nozzles generate more atomizing energy at a given fluid pressure. The Cross-Cut nozzle atomizes coatings and materials at lower pressures. About 400 to 500 psi is possible with many coatings. Low pressure airless spraying reduces material waste and equipment maintenance costs. Cross-Cut nozzles also enhance the proven advantages of airless electrostatic spray efficiency which depends on fine...

Cross-Cut® Airless Spray Gun Nozzles For more information, speak with your Nordson representative or contact your Nordson regional office. United States Amherst, Ohio +1.800.955.9563 Phone +1.440.985.1536 Fax Canada Markham, Ontario +1.905.475.6730 Phone +1.800.463.3200 Phone +1.905.475.8821 Fax Europe Erkrath, Germany +49.211.9205.0 Phone +49.211.254658 Fax Japan Tokyo, Japan +81.3.5762.2700 Phone +81.3.5762.2701 Fax Asia/Australia/ Latin America Amherst, Ohio +1.440.985.4000 Phone +1.440.985.3710 Fax © 2010 Nordson Corporation All Rights Reserved LQL-10-0586 Issued 2/10 Nordson Corporation...