NORDFAB DUCTING PRODUCT REFERENCE Quick-Fit® Sleeve with O-Ring Ordering Information • Solid welded seams prevent leakage. • Nitrile (black) O-ring included standard. • Specify Silicone (red) O-ring (high temp rating) if needed (additional cost). Replace on-site. • Used to provide variable length adjustment of QF System. Each QF pipe section is 5 ft. in length. To accommodate an existing span of less than 5', a sleeve is used to shorten. Formerly known as Adjustable Nipple. Rolled Edge (nom in.) Longitudinal seam is laser welded. Quick-Fit Sleeve Size (inches) Size (inches) O-Ring for Quick-Fit Sleeve Ordering Information • Replacement O-ring for use with Quick-Fit Sleeve. • Specify Black for standard applications. • Specify Red for high temp material. Higher quantities may require 7 - 10 working days lead time. QF Clamp attached over rolled edge and O-ring. The Quick-Fit Sleeve provides an easy way to adjust in areas where you need straight duct sections shorter than 5' Quick-Fit Sleeve Installation Instructions Measure distance to be spanned. Place O-ring on the cut pipe and slide a Quick-Fit Sleeve over the cut piece. On a Pipe, mark distance to be spanned less 4". Snap QF Clamp over O-ring and one end of Quick-Fit Sleeve. Finished connection with the Quick-Fit Sleeve Use provided O-ring to mark for cut. NOTE: POSITION CUT PIPE IN THE SAME DIRECTION AS THE AIRFLOW. Drill access hole, then cut Pipe with saw.