Nordfab In-line Spark Trap Complementary Fire Prevention for your Dust Collection System Simple, Economical Fire Protection Installed in ducting as part of a dust collection system, the Nordfab In-line Spark Trap greatly reduces the possibility of fire in cyclones / collectors by decreasing the number of sparks which could reach the cyclone or collector through the ductwork. The spark trap’s effectiveness is based on a simple principle — disrupting the laminar airflow to cause sparks to cool and extinguish before they can enter a cyclone / collector. There are no moving parts and no power is required for operation. sparks visible in airstream entering trap (closeup below) Nordfab In-line Spark Trap (shown with viewing spools on either side) Quick, Easy Installation and Cleanout Quick-Fit clamp-together ducting eliminates rivets, screws, and welding, significantly reducing the time required to install or replace ducting. The Nordfab In-line Spark Trap can quickly and easily be mounted into Quick-Fit ducting systems, or other duct systems with use of a Nordfab adapter, and the trap can easily be removed for cleanout. Calibration or other assistance from a factory technician is not required airstream exiting trap (closeup below) Galvanised Steel Must be mounted in a horizontal position. NOTE: The Nordfab In-line Spark Trap is not a replacement for spark detection or explosion isolation systems. Complementary device only. Duct distance recommended: At least ten diameters from cyclone / collector Velocity: 1500 - 5000 fpm (7,62m/sec - 25,4m/sec) www.nordfab.com The world’s fastest d