Speed Selectable Media Converter Ordering Information CSEFE1014-100 10BASE-T or 100BASE-TX (RJ-45) [100 m/328 ft.] to 10BASE-FL or 100BASE-FX 1310nm SM (SC) [20 km/12.4 mi.] Link Budget: 17.0 dB Management Features • Link Pass Through Automatic Link Restoration Field Upgradeable Firmware Supports single mode fiber Report local converter status to chassis: • Copper/fiber link status • Hardware/Software mode • 10 Mbps or 100 Mbps speed setting • Link Pass Through on/off setting Write operation includes: • Enable/disable Link Pass Through • Set speed to 10 Mb or 100 Mb Transition Networks’ speed selectable copper to fiber Media Converter allows you to extend the distance between copper based connections with the use of fiber optic cable. The ability to select the speed of converter allows for easy migration from a 10 Mbps network today to a 100 Mbps network in the future. This converter is a true layer 1 device as both the copper and fiber ports operate at the same speed setting (i.e. 100BASET to 100BASE-FX). For 10 Mbps applications, these devices must be used in pairs. Can be used with any Point System™ Chassis Specifications Standards Selectable speed setting: The converter can be set to 10 Mbps or 100 Mbps. Both copper and fiber ports are automatically set to the same speed Provides easy migration path: from 10 Mbps to 100 Mbps networks Converts copper to fiber: to assist with fiber integration into your copper network Switches 1: Link Pass Through on/off Switch Switch 2: 10 Mbps or 100 Mbps operation 3-position Jumper Hardware: Converter mode is determined by DIP switch settings Software: Converter mode is determined by most recently saved on-board microprocessor settings Status LEDs PWR (Power): Lit for normal operation F-ACT (Fiber Activity): Blinking = data reception on the fiber link F-100 (Fiber Speed): ON = link at 100 Mbps F-10 (Fiber Speed): ON = link at 10 Mbps C-ACT (Copper Activity): Blinking = data reception on the copper link C-100 (Copper Speed): ON = link at 100 Mbps C-10 (Copper Speed): ON = link at 10 Mbps Dimensions Width: 0.86” [22 mm] Depth: 5.0” [127 mm] Height: 3.4” [86 mm] Power Consumption Shipping Weight Regulatory Compliance CISPR/EN55022 Class B; EN55024; EN60950 Class B; FCC Class B; CE Mark Warranty Lifetime Extend Network Distance Ethernet Use the 10BASE-T to 10BASE-FL speed setting (back-to-back) to extend the distance between two 10BASE-T devices up to 40 km (24.9 mi.) using single mode fiber without a repeater. Fast Ethernet Use the 100BASE-TX to 100BASEFX setting to extend the distance between any two 100BASE-T devices up to 40 km (24.9 mi.) using single mode fiber or interface directly with a 100BASE-FX compliant port on any device to provide a 100BASE-T port interface. Transition Networks, inc. +1.952.941.7600 [email protected] www.transition.com ,