• Compact mould testing device for electrical hotrunner elements • Battery driven, can be used far from electrical power supply • Checks all elements wired to the connector • Grafical or table view, can be exported as EXCEL-file via USB NOLDEN MouldExpert checks the pin assignment of any arbitrary 24- or 16-pole mould connector, identifies the different elements (heater or thermocouple) and shows their operational state and characteristics. Shortage to ground on one of the pins is identified and indicated as well. The testing result is displayed on a large, bright colour touchscreen and may be downloaded as an EXCEL file via USB-plug. Measurement electronics and high contrast 7" touchdisplay are mounted in a rugged, portable plastic casing. The device is drived by a set of rechargeable batteries, which allows to be carried to any location. Charging takes place with a standard USB-C charger on any house-hould wall plug. MouldExpert is a fully automated multimeter, which measures every connector pin against every other pin as well as against earth. If a thermocouple or a heater is identified, the correspondant electrical symbol is drawn graphically between the associated connector pins on a picture of the chosen connector. In case of an earth shortage, a line from this pin to ground is drawn. All results can also be displayed as a table, in this case, beside the electrical symbol, resistance (Ohm) as well as power (W, A, rated to 230V) is depicted in case of a heater. This table can be exported with one push of a button as an EXCEL-file (csv) via the build-in USB-socket. One 24-pole or alternatively one 16-pole connector cable comes standard with the device, others are available on demand. Nevertheless, the number of measurement channels is limited to 24 + Ground. NOLDEN REGELSYSTEME GMBH Tel.: 0049-2225-70951-00 E-Mail: [email protected] Werner-von-Siemens-Strasse 18 Fax: 0049-2225-70951-99 Internet: www.nolden-regler.de - Page 1/2 - All rights reserved / Rev. 10/2024

Characteristics:Mains voltage (charger) Temperature sensor Thermocouple Fe-CuNi (J) or Ni-CrNi (K) Measurement voltage Power cable 2m, black, with EU standard plug Charger USB-C wall plug charger Battery life appr. 6h SUB-D to 24-pole heavy duty connector (female) or SUB-D to 16-pole heavy duty (female) comes standard, each 1,5m long. Others as e.g. 16-pole narrow series (male/female) available on demand. Projected capazitive 7“ TFT colour-touchdisplay NOLDEN REGELSYSTEME GMBH Tel.: 0049-2225-70951-00 E-Mail: [email protected] Werner-von-Siemens-Strasse 18 Fax: 0049-2225-70951-99 Internet:...