NHmSEVKD Minimize workpiece waste due to defects. Single-axis automatic screw driving machines FM513VZR Ultra-low thrust model Self-weight cancellation function Calculate and offset the weight of the screwdriver bit lift mechanism Ultra-low thrust The thrust force.during screwitightening reduced by approx, by self-weightcancellation .function High-speed slide Screwing ] Check for screw height fault | Minimizing the load on the workpiece and reducing screw-tightening defects ^ Reducing defects previously difficult to prevent © Easy thrust setting Set thrust [N] directly, regardless of the installed driver or tightening direction Prevent ±- diagonal tightening * Compared to the conventional mode * Thrust is set at the tip of the bit • The maximum thrust is as same as that of the conventional model Reduce the load on the workpiece Thrust of the conventional model The deflection of thB workpiece effects I the detection of screw height fault To prevent deflection of the workpiece by reducing the thrust force during tightening, the screw height fault detection accuracy is also improved. Advanced thrust control y Maxspeed approx: Control] processing speed UP -t Shortening cycle time Time of Start ► Screwing ► Return • Compared to the conventional model * Compared to the conventional model * Screw feed time is not included. * Cycle time depends on

Operation panel Screw driver controller Sensor cable (only case of NX driver) Motor cable Encoder cable H External signal cable Power cable Motor cable Encoder cable External signal cable (Option) Power cable External signal cable Controller box External signal cable Air hose (Provided by customer) Cable carrier is standard equipment Contributes to cable protection and maintainability •1: The type of driver varies depending on target torque. *2: Products will be built up based on specificatio of screws, therefore it can be used for one kind of screw only. *3: Application range of screws will...