Max. Tightening Torque_Nm {kgf-cm} For Multi-Port Connection (Automatic) Multi Cupla MALC-HSP Type Low spill type for high pressure use Working pressure Valve structure Applicable fluids A single operation enables simultaneous connections of multiple lines. A special design minimises air admixture in fluid lines upon connection. Suitable for high pressure hydraulic circuits. • Compared with conventional Multi Cuplas, approximately double flow rates are realized. This could reduce the size of required plates. (Rate of flow increase depends on Cupla sizes.) • The MALC type realizes a 2 mm axial eccentricity allowance, while the conventional Multi Cupla is only 0.6 mm. • Special valve design enables connection of socket and plug under dynamic pressure of up to 8 MPa. • When connected, the distance between the socket plate and plug plate is designed to be 30 mm for all sizes. This means any size of Cupla can be mounted and used on the same plate. • Low spill valves minimize outflow of fluid and admixture of air into the fluid line. MALC-HSP (Thread screw mount) type (Plug) Socket and plug in the same size can be connected regardless of their end configurations. * Assign the actual value of pressure [P (MPa), p (kgf/cm2)] to the above formula to calculate the load. Maintain the connection with the minimum load or more, but not more than the maximum acceptable load. Flow Rate - Pressure Loss Characteristics MALC-HSP (Flange) type

WAF : WAF stands for width across flats. MALC-2 to 6HP-FL type (With flange) Socket MALC-2 to 6HS-FL type (With flange) ^3 (7.6) Mass (g) Li Plug MALC-8HP-FL type (With flange)Socket MALC-8HS-FL type (With flange) Model Application MALC-8HP-FL See P117 Mass JO)__Li Before use, please be sure to read "Safety Guide" described at the end of this book and "Instruction Sheet" that comes with the products.

MALC-2 to 8HSP-FL type (With flange) Before use, please be sure to read "Safety Guide" described at the end of this book and "Instruction Sheet" that comes with the products.