YEL35 SERIES
7Pages

YEL35 SERIES 35W YEL35 series are designed with lower profile housing and for wide range AC input from 90VAC to 264VAC. In addition to the high efficiency,Delivering an extremely low no load power consumption. the design of metallic mesh case enhances the heat dissipation. The good performance can be used for industrial automation & control systems, varied equipments etc. Universal AC Input/ Full Range Cooling by free air convection High operating temperature up to 70 ℃ Higher Efficiency/Low Power Dissipation Protection:Short Circuit/Overload/ Over Voltage Three Years Warranty

Model Information Yingjiao Part Number Rated Current Rated Power VOLTAGE ADJ.RANGE Input VOLTAGE RANGE FREQUENCY RANGE INRUSH CURRENT(Typ.) LEAKAGE CURRENT

Output RIPPLE & NOSE(max.) VOLTAGE TOLERANCE LINE REGULATION LOAD REGULATION SETUP TIME 1000ms/230VAC at full load 2000ms/115VAC at full load RISE TIME 30ms/230VAC at full load 30ms/115VAC at full load 30ms/230VAC at full load 12ms/115VAC at full load

Protection OVER LOAD 110%-150% Rated Output Power Protection type: Hiccup mode, recovers automatically after fault condition is removed OVER VOLTAGE 5V:5.75~6.75V 12V:13.8~16.2V 15V:18.75~21.75V 24V:28.8~33.6V 36V:41.4~48.6V 48V:55.2~64.8V Protection type : Shut down o/p voltage, re-power on to recover Environment WORKING TEMP. -30 ℃ to +70 ℃ (Refer to "Derating Curve") Working Humidity STORAGE TEMP, HUMIDITY TEMP. COEFFICIENT 10~ 500Hz, 5G 10min./1cycle, 60min. each along X, Y,Z axes OVER VOLTAGE CATEGORY III; According to BS EN/EN61558, BS EN/EN50178, BS EN/EN61000-3-2,-3；BS EN/EN62477-1;...

SAFETY & EMC SAFETY STANDARDS WITHSTAND VOLTAGE ISOLATION RESISTANCE I/P-O/P, I/P-FG, O/P-FG:100M Ohms/ 500VDC/25 ℃/70% RH Note 1.All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25℃ of ambient temperature. 2.Ripple&noise are measured from peak to peak with band width limit of 20MHz(0.1uf and 47uf /50V parallel capacitor under DC output full load, AC nominal input 25 ℃ ambient temperature). 3.Derating may be needed under low input voltages. Please check the derating curve for more details. 4.The power supply is considered a component which will be...

Block Diagram

Deduction curve and temperature Minus output and input voltage curves