SUBMINIATURE AUTOMOTIVE RELAY Features Tight structure and light weight Improved heat resistance ROHS&ELV compliant Typical Applications Central door lock,power doors&windows,Turing lamp control, Mirror adjustment,Seat adjustment,Speed-limit indicator control, Warm-up control,Wiper control CHARACTERISTICS Contact arrangement Max.switching current2) Max.switching voltage Min.contact load Electrical endurance Release time Shock resistance 5) Vibration resistance 5) Ambient temperature Unit weight Mechanical endurance Initial insulation resistance Dielectric strength Operate time Plastic sealed Flux proofed Notes: 1) Equivalent to the max.initial contact resistance is 100mΩ (at 1A 6VDC). 2 ) At 23℃,13.5VDC(100 cycles,resistive load). 3)1min,leakage current less than 1 mA. 4) The value is measured when voltage drops suddenly from nominal voltage to 0VDC and coil is not paralleled with suppression circuit. 5 ) When energized,opening time of NO contacts shall not exceed 100μ s,when non-energized,opening time of NC contacts shall not exceed 100μ ,meantime,NO contacts shall not be closed. s Max.allowable overdrive Voltage 2) VDC Max.allowable overdrive Voltage 2) VDC at 23℃ Notes: 1) Other types on request. 2) Max. allowable overdrive voltage is stated with no load applied.

CONTACT DATA Load current A Load voltage Load type Contact material Load wiring diagram 4) Motor Locked 1) When it is utilized in flasher, please connect by the polarity according to the diagram4 below. 2) Corresponds to the peak inrush current on intial actuation (cold filament). 3) Corresponds to the peak inrush current on intial actuation (motor). 4) The load wiring diagrams are listed below (Ratings of NO,NC are tested based on different samples seperately): Motor Lamp 5) When the load voltage is at 24VDC or higher,or the applications are different from the table above,please submit the detailed...

OUTLINE DIMENSIONS,WIRING DIAGRAM AND PC BOARD LAYOUT Unit: JT3FD SUBMINIATURE HIGH POWER RELAYmm Outline Dimensions(1 Form A / 1 Form C) 15.5 PCB Layout (Bottom view) Wiring Diagram (Bottom view) Remark:1)The pin dimension of the product outline drawing is the size before tinning (it will become larger after tinning), and the mounting hole size is the recommended design size of the PCB board hole. The specific PCB board hole design size can be mapped and adjusted according to the actual producet. 2) In case of no tolerance shown in outline dimension:outline dimension ≤1mm,tolerance should be...

CHARACTERISTIC CURVES LOAD CURVE ( at 23°C) Coil Temperature Rise Temperature rise (K) Electrical Endurance Curve Coil power Notes: 1. Curve A: NO contact Curve B: NC contact 2. Test conditions: Curve A : NO, Resistive load, Room temp., flux proofed, 13.5VDC, 2s on 2s off Curve B: NC, Resistive load, Room temp., flux proofed, 13.5VDC, 2s on 2s off Disclaimer The specification is for reference only.See to “Terminology and Guidelines”for more information.Specifications subject to change without notice.We could not evaluate all the performance and all the parameters for every possible application.Thus...