SUBMINIATURE HIGH POWER RELAY Features 10A switching capability 1F o rm A and 1F o rm C configurations Standard PCB layout Plastic sealed and flux proofed types available Product in accordance to IEC 60335-1 available Environmental friendly product (RoHS compliant) Outline Dimensions:(18.4 x 10.2 x 15.3)mm CONTACT DATA Contact arrangement Contact resistance Contact material Contact rating Max.switching current Standard type Pick-up Voltage VDC 1) Max.switching voltage Electrical endurance COIL DATA Nominal Voltage VDC Max.switching power CHARACTERISTICS Insulation resistance 2)Applicable when NC is not energized with load. Notes: 1)The data shown above are intial values. Sensitive type (Only for 1 From A) 1000MΩ(at 500VDC) Between coil&contacts Between open contacts Dielectirc strength Coil power Operate time(at nomi.volt.) Release time(at nomi.volt.) Functional Shock resistance Vibration resistance Ambient tenperature Termination Unit weight Construction PCB Approx. 6g Plastic sealed, Flux proofed Notes: 1)The data shown above are intial values. JINTIAN RELAY ISO9001、ISO14001、OHSAS18001 CERTIFIED Notes: 1)The data shown above are intial values. 2)*Maximum Volt

SAFETY APPROVAL RATINGS AgCdO AgNi AgSnO 2 AgCdo AgNi AgSnO 2 AgCdo AgNi AgSnO 2 Notes: 1) All values unspecified are at room temperature 2) Only typical loads are listed above.Other load specificationgs can be avaliable upon request. ORDERING INFORMATION JT3FD SUBMINIATURE HIGH POWER RELAY Type Coil voltage Contact arrangement H:1 Form A S:Plastic sealed Nil:Flux proofed Contact material Contact material Q:High capacity(Only for Sensitive) Contact material Special code Nil:Standard Nil:Standard XXX:Customer special requirement Notes:1) We recommend flux proofed types for a clean environment(free...

OUTLINE DIMENSIONS,WIRING DIAGRAM AND PC BOARD LAYOUT Unit: JT3FD SUBMINIATURE HIGH POWER RELAYmm Outline Dimensions Wiring Diagram (Bottom view) (Bottom view) Remark:1) The pin dimension of the product outline drawing is the size before tinning (it will become larger after tinning), and the mounting hole size is the recommended design size of the PCB board hole. The specific PCB board hole design size can be mapped and adjusted according to the actual producet. 2) In case of no tolerance shown in outline dimension:outline dimension ≤1mm,tolerance should be ±0.2mm;outline dimension＞ 1mm and≤5mm,tolerance...