Operating guideline Poster - SCRUBTEC 337.2 ATTENTION! Do not use the machine before you have read and understood the Instructions for use manual 1. Check the battery charge LED light (and if necessary re-charge). 2. Fill-in the tank with clean water. 3. Always follow the dilution 4. Check the brush is clean and install it instructions on the label of the chemical on the deck. product used to prepare the solution. The solution temperature must not exceed 40°C and be no foaming. 5. Turn the knob on one of the indicated programs. 6. Press the enabling red button together with the brush levers for starting floor cleaning. 7. Press the solution flow control button 8. Turn the knob to 0 position to switch off the machine. depending on the type floor and cleaning conditions. 9. At the end of the work, empty the recovery tank and clean it with clean water. 10. Wash the vacuum grid with clean water. 11. Remove the brush and clean it from debris. 12. Disconnect the squeegee hose from the squeegee. 13. Take the squeegee off and check the blades’ wear status. If needed, replace them with new ones. 14. Clean the squeegee blades with water. 15. Clean the machine using a dump cloth and if needed, use a neutral cleaning product. 16. Park the machine with the recovery tank open. Nilfisk A/S Kornmarksvej 1 DK-2605 Brøndby Denmark