Proportional motorised valve TYPE ED01 Electrical proportional valves made of stainless-steel are used to control the flow in a system. The electrical actuator allows to regulate the flow proportional tot he input signal. suitable for liquid & gaseous media actuator rotatable through 360° anti-waterhammer design (fluid entry under the disc) LED indicators for valve status display Valve keeps position in case of power failure vacuum operation up to 10-2 mbar high flow-rates construction: with electric actuation design: body material: top cover material: seal: mandrel seal: pressure: setpoint: motor consumption: display: voltage: connector specification: enclosure protection: temperature: actuating time: mounting position: viscosity: flow regulation characteristics: motorised proportional valve stainless steel 1.4404 translucent polyamide (PA) FKM/FPM FKM/FPM 0 – 10 bar static Differential pressure see table dimensions 0 – 10 Volt (input resistance 10kW) 4 – 20mA (input resistance 500W) 12W in operation | <2W holding phase/setpoint position Max. peak current 0,7 A LED 24V DC +/-10%, max. ripple 5% EN 175301-803, form A IP65 (EN60529) media: -10°C up to +145°C ambient: -10°C up to +50°C (steam and hot media up to +40°C) <1,3 s full opening | <1,3 s full closing any max. 600 mm2/s linearity ±5%; hysteresis < 3%; accuracy <3%; sensitivity < 3%; repeatability <3%

Datasheet dimensions: status valve OPEN valve CLOSED valve moves to open valve moves to close LED green orange green flashing green flashing feedback signal (24 V switch)

Datasheet Switching cycles: The switching cycles depent on the ambient and media temperature. For rough orientation, see the following table: Media temperature Ambient temperature Cycles / min Features: • ready-to-use valve • long service life • High flow due to angled seat design • Fluid isolation between motorised actuator and valve body • LED indicators for valve status display • Valve tight at closing position (FCI 70-2 class V) • Vlave satisfy Pressure Equipment Directive 2014/64/EU, article 4.3 • Proportional motorised valve complies with the essential requirements of EMC Directive 2014/30/EU...