TM / TR series
9Pages

Super-miniature Illuminated Pushbutton Switches

W&<D!RW/Pan Numbering Series code Contact plating Type of contact Structure Type of Contacts and Contact Plating 3 ti fs -y—# £ >S2#B#/When color button is mounted. LED color symbol must be specified in place of I

TR(y/<— □ V h/Conductive Rubber Contact) Terminal number not shown on box. Terminal number not shown on box. Terminal number not shown on box. f-LOB. LOOrt Switching function Dual color (ON): Momentary LED color symbol must be specified in place of ■. ■ : See page 169

+ : Made to order products ON): Momentary LED color symbol must be specified in place of ■. ■ : See page 169

Kft^f/'S/Mounting Dimension Mounting Frame □ 10ffl aW#/Mounting Frame /Mounting Frame Mounting Frame Mounting Frame Mounting frame Mounting frame O When the switch is used with the button without the mounting frame, be careful to guide the button by a panel board of a user. (Dimensions of panel cut-out are recommended to add 0.4~0.5 mm each side to a button size.) \-fl) > hSffi?L*W-^}S/PC Hole Layouts (TR3 ■ TM3 ■ TMG3) ►Pay attention to the polarity of LED ►LED color symbol must be specified in place of I ■flli!H±ti/Packaging Specifications

IBUTcfflJlpPiEi/Optional Accessories (SftSBS/Supplied Separately) Part Name vJUA*- Silver Part Name : Optional Accessories

IS'JTcttJlnBifn/Optional Accessories (S#pBpnp/Supplied separately) Part Name Dark gray Light gray Part Name Mounting Frame Mounting Frame □12.6 Button type Mounting Frame Dark gray

Current to be applied on LED must . l l , I rvWr* be lower than the forward current specifications. Value of the resistor mula noted right. Install mounting frame direction as switch slot. Install button making dents of button meet longer side Mounting frame should be installed before button is ■fllffliSJ&KOHT/Ambient Conditions- The gold-plated switch has great resistance to corrosion, is recommended in areas where sulfuric gas, ammonia gas, or other corrosive gas will adversely affect the silver plating to cause contact failure. Preheat should be within 80-120°C, 120sec. tiu&t w£<*t\,...

I iBS—M^/Table of Part Numbers The above-listed are switch part numbers only. If Buttons and/or Mounting Frames are required, specify accessory part numbers (available at i. : Inquiry products. : Semi-standard products. * : Made to order products