^NEX FLOW™ FRIGID-X™ SUB ZERO VORTEX™TOOL COOLING SYSTEM frigid-xtm sub-zero vortextm tool cooling mist systemWhen lubrication is required as well as cooling, lubricating mist can be reduced and cooling enhanced WHAT ARE THEY - REASONS TO USE Heavy coolant can be messy, costly and must be carefully maintained. In addition, dry machining is not always possible due to the need for lubrication or additional cooling that cold air alone cannot provide. The unique patent pending low cost Frigid-X™1Sub-Zero Vortex TM Tool Cooling Mist System is ideal for such applications. The unit is comprised of a coolant/lubricant suction system which draws any water based liquid into a specially designed delivery system. This cools the liquid to deliver a very cold fluid "mist" at around 40 degrees F (5 degrees C). This cooling allows for as much as 20% less coolant needed, faster production rates and improved quality. The liquid is cooled by means of a small vortex tube that uses around 5 SCFM (142 SLPM) at a maximum of 50 psig (3.5 bar). Pressure can be adjusted up or down slightly to avoid freezing of the liquid or to get a colder temperature. An adjusting screw controls the level of mist required. Liquid is siphoned into the unit using a long plastic tube connected to the main unit. A heavy duty removable magnet secures the Sub-Zero Vortex™1 Tool Cooling Mist System onto a machine. The magnet can also be removed and mounting holes may be used to secure the mist system. All you need is the liquid to cool and/or lubricate and a small amount of filtered (clean) compressed air at 50 psig (3.5 bar). No electrical components, no expensive pumps or moving parts except for the adjusting screw assures long life and maintenance free operation. Frigid-XTM Sub-Zero Vortex ™Advantai ► No electricity required - simplicity in design low cost ► reduces coolant/lubricant cost using by less fluid ► improves safety with less mist ► no moving parts except for an adjusting screw for the fluid ► small and lightweight, portable ► maintenance free operation Frigid-X TM Sub-Zero Vortex ™Advant; ► Solid Carbide End Mills wherever lubrication is required in machining when cooling is required beyond the capability of cold air alone Nex Flow™ Air Products Corp. 10520 Yonge Street, Unit 35B-220 Richmond Hill, ON, Canada, L4C 3C7 Tel: +1-416-410-1313 Fax: +1-416-410-180 or +1-716-6

^NEX FLOW™ FRIGID-X™ SUB ZERO VORTEXTMTOOL COOLING SYSTEM SUB ZERO VORTEX ™ TOOL COOLING SYSTEM FRIGID-X™ TOOL COOLING SYSTEM MIST COOLANT & LUBRICANT TM TM The Frigid-X Sub-Zero Vortex Tool Cooling Mist System may use any water based material including water itself. Non-water based materials are not recommended as they may dry and clog the system. If you need a coolant/lubricant material Nex Flow can also supply: SUB ZERO VORTEX ™ TOOL COOLING SYSTEM E-mail:- ■ [email protected] ■ [email protected] ■ [email protected] Web:- ■ www.nexflow.com ■ www.nexflowair.com ■ www.nex-flow.com