MID-POWER Q-SWITCHED LASERS The HIPPO Advantage • Rugged, industrial design for reliable 24/7 operation • A single laser platform that enables up to 4 different wavelengths: 1064 nm, 532 nm, 355 nm, 266 nm • Modular design allows easy field change of key components, including the harmonics module • High peak power and short pulse lengths minimize thermal damage to substrates • Excellent mode and pulse-to-pulse stability for consistent processing The Spectra-Physics HIPPO lasers are a family of high power diode-pumped solid state (DPSS) Q-switched lasers with available outputs of 1064, 532, 355, and 266 nm wavelengths. With an extensive history and a strong performance record in industrial uses around the world, HIPPO is the tool of choice in applications where uptime is critical. HIPPO’s modular design allows easy field replacement of key components including diodes, the laser output window, and the harmonic module without costly tool realignment. Excellent Performance HIPPO Q-switched lasers are characterized by high peak power and short pulse widths, which minimize undesirable thermal damage such as heat affected zones, recast material, kerfs, and micro-cracking of the substrate. All HIPPO Q-switched lasers have excellent TEM00 beam quality, which ensures a large depth of field and guarantees consistent and reliable scribing results over a wider range of material flatness, thickness, and surface variations. HIPPO lasers have stable power, low pulse-to-pulse energy variation, and stable beam pointing over a wide range of operating conditions, including time, temperature, and pulse repetition rate. High Reliability HIPPO lasers have a number of unique design features that significantly increase both the laser life and uptime. The HIPPO lasers’ modular design separates known wear components and key failure mechanisms into small components that are easy to change in the field without costly tool realignment. This lowers service inventory holding costs while shortening mean time to repair (MTTR). Crystalline Silicon solar cell edge isolation Flexible circuit board processing/drilling/cutting Glass cutting Laser ITO patterning Scribing of thin film solar cells Sapphire (LED) scribing Si wafer scribing Si wafer marking Marking metals and plastics Via drilling flip chips and PCBs

HIPPO™ HIPPO 1064-27 Typical Performance1 Power Pulse Width Power Pulse Width Power Pulse Width Power Pulse Width HIPPO Prime 266-2 Typical Performance1 5 Power Pulse Width 1. Typically measured performance; not a guaranteed or warranted specification.

General Characteristics Wavelength Power Repetition Rate Peak Power Pulse Width, nominal Beam Characteristics Spatial Mode Beam Diameter, at waist Waist Location, nominal Beam Divergence, full angle Beam Ellipticity Beam Pointing Stability Pulse-to-Pulse Stability Operating Conditions Warm-up Time Temperature Range Water Cooling Water Temperature Water Flow Rate Thermal Load Non-operating Conditions Temperature Range Altitude, Non-operating Humidity, Non-operating Physical Characteristics Dimensions (Laser Head) (L x W x H) Weight (Laser Head) Dimensions (Power Supply) (L x H x W) Weight (Power...

HIPPO™ HIPPO Laser Dimensions A Side View Front View HIPPO 355-5 HIPPO Prime 266-2 HIPPO Power Supply Dimensions 1.60 (40.6) Laser Enable Laser Emission 0.50 (12.7) Side View All dimensions in inches (mm) 3635 Peterson Way, Santa Clara, CA 95054, USA PHONE: 1-800-775-5273 1-408-980-4300 FAX: 1-408-980-6923 China +86-10-6267-0065 [email protected] France +33-(0)1-60-91-68-68 [email protected] Japan +81-3-3794-5511 [email protected] Taiwan +886 -(0)2-2508-4977 [email protected] Singapore +65-6664-0400 [email protected] EMAIL: [email protected] Belgium +32-(0)0800-11...