NSC-M Series The NSC-M Series motion controllers are designed for use with all Newmark stepper motor systems. The controller can communicate with the host computer through an RS-232 interface. It can manage up to four axes and perform coordinated or independent motion of each or all the axes simultaneously. With built-in high level functionality, such as circular and linear interpolation, multi-tasking and custom profiling, programming the controller is greatly simplified. File Terminal Help {Attempting to contact OMS device___} The motion controller can operate as a stand-alone system through trajectory profile, acceleration, velocity, deceleration and direction commanded using virtually any programming language to pass simple ASCII command strings to Program Sample This program will move the motor 34,000 steps back and forth until the stop(ST) command is executed. * start of loop for repetitive motion * move relative +34,000 steps * move relative -34,000 steps * loop back to starting WH command The terminal software is an easy to setup and use interface for NSC-M programming. Model Description NSC-M2 Two Axes Stepper Motor Controller NSC-M2-E Two Axes Stepper Motor Controller with Encoder Feedback NSC-M3 Three Axes Stepper Motor Controller NSC-M4 Four Axes Stepper Motor Controller Ordering Information